Installing ridge cap on standing seam metal roof system step by step how to..
Рет қаралды 4,737
2 жыл бұрын
@swisharamful 2 жыл бұрын
You make it look easy carnal! Saludos
@ovi1013 2 жыл бұрын
Saludos carnal I’ve just been doing it a while
@john2359 2 жыл бұрын
I’m 63 years old and I’m not afraid to bungee jump 240 feet. Take a look at my channel I think I have maybe 4 videos but if that was my job I’m pretty sure I would fall off and hurt myself. lol The older you get the more your balance goes away.
@ovi1013 2 жыл бұрын
Your not kidding about the balance.. I’ve been noticing myself
@Teal-od1ze Жыл бұрын
Do you see any issues with installing this set up (vented z bar and metal ridge cap) on a shingle roof? Our ridge beam is to wide for a normal shingle ridge vent so I was thinking a metal ridge cap with vented z bar may work with our shingle roof?
@ovi1013 Жыл бұрын
I’ve done it before it works just fine .. go for it
@Teal-od1ze Жыл бұрын
@@ovi1013 any certain screws that should be used for attaching the z bar to the decking through the shingles? Or anything else I should be aware of to avoid any issues down the road?
@ovi1013 Жыл бұрын
@@Teal-od1ze I would use 1.5 inch hex head screws with washers you should be fine .. have Atleast 4 inches of overlap from shingles to the tip of the z bar
@ovi1013 Жыл бұрын
@@Teal-od1ze if your not in hi winded area 3 inches or so is good
@Teal-od1ze Жыл бұрын
@@ovi1013 thanks!
@SteveEisses 2 ай бұрын
That isn't 24 ga. The stuff I use does NOT flex like that.
@ovi1013 2 ай бұрын
It’s 24 ga.. I’ll bet you whatever you want
@hempseedaddict 2 жыл бұрын
Cuts like buttah
@ovi1013 2 жыл бұрын
Yup smooth and greasy lol
Los Ruferos KC
Рет қаралды 185 М.
The Metal Roofing Channel
Рет қаралды 113 М.
Metal Roofing Learning Channel®
Рет қаралды 29 М.
RR Buildings
Рет қаралды 380 М.
The Metal Roofing Channel
Рет қаралды 6 М.