I been following your progress for months, I am also do a complete restore of a 13', unfortunately It is going very slowly. Watching your progress keeps me motivated. Excellent work!

Man that is aersome thanks

Great job

Jose. You mentioned that you used KiwiGrip on the floor and wasn't happy with the results. I used the Soft Sand rubber particles and was very pleased with the results. I would, however, recommend using the 'fine' grade. Before doing mine, I researched and one person on KZfaq used the coarse and said it was very difficult to clean. I've had no problem cleaning mine. Instructions describe 2 options: 1) - mix in the paint and apply; 2) - apply a coat of wet paint, sprinkle liberally, remove access then add another coat of paint on top. I chose the 2nd option and was very pleased.

Jose! That interior looks great! You did a good job on it. As I mentioned in an email, I may work on a console later this fall. Looking at your installation I didn't quite think ahead and made both seat clamps the same. I may have to think this out a little more when I get ready to build. On the gripping material I decided not to put it on the floor, but I did put some at the front of the boat at the rail ledge and around the storage compartment, mainly because I always get in/out of my boat from the front. I used the Soft Sand and it worked out really well.

Coming along sweet bro. I just got delayed further in mine. We have been getting nasty storms coming our way and I don’t want to be outside fiddling with the boat in a storm. Good job on yours man

That is a beautiful boat!! Hope you’re gonna show some fishing videos from it 🇺🇸👍

Looks awesome! Great job

Looks great.

I'm currrently restoring a 13" whaler and your videos have been very helpful. Couple of questions: 1) Have you noticed having the gas tank and battery at the stern, does the added weight create a problem getting on plane or porpoising? 2) How did you measure where to place the seats? Thanks

looking great man !!

Jose, I believe they sell entire kits of mahogany interior. Did you use that?

Jose. Great videos as usual. I noticed in your varnishing video the console was already assembled. Did you do the assembly or was it so straightforward that a video wasn't needed?

Good work, looks great! My baby Whaler is stripped down and ready for top paint but for now its at a Yamaha shop for service on the 40 horse. To hold down weight I purchased a 40th Anniversary interior kit without the seatback and storage unit though it has the same bigger console. Am looking at installing the rear bench on top of the side clamps - another 4" of height would be nice and it would create a good space for the gas tank - but then again I may install in the standard manner and put in a couple of Millenium seats on short pedistrals. Not sure I'll use the front bench been wondering about use as a rear casting platform? And I want to push the rear bench seat forward 4" to 6" and maybe put the battery under the console. Don't tell my wife this but I'm looking at about $3K for my refit.

Hi I have I question I’m trying to install the interior in my whaler but I don’t know where to screw the side boards, is there any measurements, or how can I know where the put the side boards ( it’s my first boat and I don’t know much thanks In advance)

Nice Job! What stain if any and varnish did you use?

Hello I have a little 13 whaler too how did u get the back seat backrest and the compartment

Why’d you decide to do that to the floor vs leaving it blue how you had it? (curious because I’m trying to decide what to do with my whalers floor)

where did you get the kit interior kit from?>

Do you have any templates for the wood?

Hello , I see that you upload new video . I want to buy your channel, please reply