Got my SimCore UH1-55 extension today and shot a little install video. Enjoy! Link to UH1-55: simcore.com.au/uh1-55 My Stuff: Twitch(Tuesday and Thursdays @6PM) : / gt_greg Instagram: / flatsick discord: / discord
Пікірлер: 43
@AB-30814 күн бұрын
Thanks for the video - one part that's left out: once you get the 2nd set of bolts out, take two of them and put them in the other two holes and tighten slowly until you feel the clamp release.
@mannyfresh7065
FYI the manual says the torque for those 4 bolts is 5-10Nm
@brodeur2123 жыл бұрын
is that hub 5,5cm or 5,5+ 4cm from the og one
@user-mi5bz7wm2p
sim lab or simcore Extensions which one is a better extensions.
@JUSTICEKILLERXX
No way just wiggling this thing works
@thejohnnysims2 жыл бұрын
can You tell what is inner diameter of this extension?
@michalmikus21032 жыл бұрын
Hello guys, when i have VRS base with standart VRs HUB i must take off VRS hub and then i can put this simcore spacer? Ant its compatible with xero play qr? Thank you
@frosty3272 жыл бұрын
So anyone have a torque spec for the bolts yet ?
@chrisjohnson2613 жыл бұрын
I keep hearing that the motor wasn't designed for this. Have you had any issues with this at all like performance or technical problems
@OhItsThat3 жыл бұрын
I ordered the UH1-75 and a 50mil Gold Pro XT. If i don’t end up using the XT you wanna review it? I’m in the states.
@miltonfullwood37913 жыл бұрын
Well done
@Neilmcconnon
Thanks man 👍🏻🍻
@cdnsimracer78013 жыл бұрын
Nice vid Greg!
@LeonardoMarchese3 жыл бұрын
UPDATE: I did remove the clamp by using two of the M6 bolts (previously unscrewed) in the two of the threaded holes, once it bottoms half an extra turn clockwise will unlock it.
@EKG14 Жыл бұрын
Hey I did the same but have serious play and clonking when hitting big curbs or high compression zones. Plz help
@GaragemdoCaio3 жыл бұрын
Hey mate. Where did u get those button plates and the screen (with the screen support) They are very nice . Good video. 👍🏼👍🏼
@MBimmer3 жыл бұрын
Nice stuff.
@04GEEDOGG3 жыл бұрын
Hey Greg i just received my extension and I can't get the base side quick release off I've tried M4,M3.5 allen keys and they are to big and the M3 is too small. I noticed in your video you said they were M5s.
@rayjubb87263 жыл бұрын
Great video. But they didn’t put any bolts in with my extension.