Рет қаралды 97,497
Learn how to set up an internal SOLIDWORKS Flow Simulation analysis on a piping system. Internal analyses are widely used for piping, manifolds, electronics enclosures, and many other other applications. Internal analysis require lids or other coverings to create a watertight fluid region. Flow Simulation analyzes this region exclusively to greatly improve solution time.
Boundary conditions such as flow rate and pressure openings are specified. Goals are established to track key parameters and ensure solver convergence. The project is run and later cloned to test a variation. Results interpretation is also discussed.
Download the files here: www.dropbox.co...
Presented by Ryan Navarro
For a guide to Meshing in Flow Simulation:
• Meshing guide for SOLI...
For setting up an external or thermal analysis in Flow Simulation:
• Thermal Analysis in SO...
The same analysis performed in SIMULIA Fluid Dynamics Engineer:
• Internal Pipe Flow in ...
0:00 Introduction
0:59 Getting Started in SOLIDWORKS
1:30 Creating Lids
1:58 Project Wizard
2:59 Boundary Conditions & Goals
4:30 Run the Project
5:10 Interpreting Results
6:30 Cloning Project
7:32 Tips & Wrapup
For more information on SOLIDWORKS: hawkridgesys.c...
For more information on SOLIDWORKS Simulation: hawkridgesys.c...
Technical Support Knowledgebase: support.hawkri...