Bro, i want to get one , can u tell me the exact model of the most powerful Dan Wsson, becouse i see there are a lot diferents. Thanks u

@@kavxvm2028 The 8 inch one

@@HappyDude1 thanks, i say that becouse i see there are different 8 versions , 4.5mm , 6mm and if yours is a special powered one

@@kavxvm2028 The 4.5 mm steel BB has the most destructive power

@@HappyDude1 OK, thanks u bro :)

Yes i really try it out for myself And then let you guys see it Even if it doesn't work....

@@HappyDude1 and I hope you have now learned that it dont work,, try swopping the Co2 valve over for the 3-inch snubby valve,,. that valve has no red stripe across it as its a high presser high flow valve, the only thing we half agree on is,, ""more Co2 more FPS,"" but it's really a case of,, """"more Co2 at higher presser""" give's you more FPS! so fit the high flow high presser valve!

Just buy it 😀

​@@HappyDude1 How much

Thank you

its connected to a pressure tank with 200 bar of pressure, you can maybe do 50 shots and then everything breaks :p

@@HappyDude1 not neccesarli need to shoot at 200bar, maybe at an slight increase from the stock 80bars or whatever normal co2 produces at 20c

Can't opet privat video

Yes it is I like the colt more better quality

But it shot slower with the upgrade.. Wtf

@@airgunballistics1779 well that was not much of an up-grade then, was it? it was more like a very big down grade!, I take it you know that the Dan Wesson is a "LOW powered revolver", you may just about get one joule or around 1 ft,lb out of it, and putting a stronger hammer spring into it won't really make any difference to its power output, as the power output is governed by the amount of gas and Presher of that gas pushing the pellet down the barrel, there is a lot more to be taken into account like valve timing and valve overlap timing, added to that, it's gas porting and it's gas flow ratting, however there are two different valves fitted to the Dan Wesson revolver's, the short barreled (2 inch snubby) Dan Wesson has the most powerful valve fitted in it, as it has a very short barrel so the revolver need more gas for it to work right,, the snubby's valve is a high power high flow valve and has no red strip across it, (so you will be using more gas up) but the 6 inch valve is a low powered valve and dose have a red strip across it, both valves are interchangeable, just buy the more powerful valve out of the 2 inch snubby, and swop it over! , at today's price that valve would cost you around £20!, and the trigger is not made any harder to pull, adding accuracy, nor is any extra stress put on any of the gun's part's, so with this kind of Dan Wesson "up-grade", cranking up the hammer spring tension. dose next to nothing in gaining extra power! but it will pull the revolvers accuracy way down, unless you have the strength and the grip of a griller! you will also find out that your revolver will need new parts fitted very soon as this upgrade (down grade!) will very soon start destroying its trigger pin's and hammer pin's! I hope that has helped you in your quest for this extra power! extra power that will be near imposable to achieve.

Its true you know 😁

U can't swap them over . 1 is a lot shorter valve housing than the othere 1...unless you now otherwise

​@@JonathanWilliams-gd2wn He's a grump with too much time and too many keyboard strokes.