Is Springfield's RONIN 10MM 1911 Any Good? PART 2

Рет қаралды 2,417

Жыл бұрын

We give the Springfield Armory Ronin 10mm 1911 a second range test, this time with different ammo. Did this fix the problems from the first test? Watch to the end to find out.
Please support us on Patreon so we can continue to bring you more and better videos,. Plus, get our comprehensive guide to hunting cartridges*: patreon.com/locacarnivorehunter
For more great content, please visit our website: www.locacarnivore.com
At time of publication, LocaCarnivore had no commercial interests in any products or brands mentioned in this video.
*Book when you contribute at the appropriate level.
For more detail on the Springfield Armory Ronin 10mm 1911's second range test, read the companion article: www.locacarnivore.com/2023/04/20/springfield-armory-ronin-10mm-1911-episode-ii-the-ronin-strikes-back/

Пікірлер: 13

@kentdurham2716 3 ай бұрын

Hi, at the range you are shooting, accuracy should be terrific. I would find other ammo that your pistol likes as far as function that shoots center of the bull. Erratic shots shown in the video are not worth the time. Cheap ammo ( I mean poor accuracy from ammo) can be not only frustrating but misleading of your shooting skills. When you find some accurate ammo that your gun likes confidence soars and gives assurance. As an aside, your barrel may not be returning to battery the same after each shot. This will also cause inconsistency in where your bullet lands. It can be common for a first shot to fall outside your group but with the ammo you show, there isn’t really a classic group. It sounds like you were more interested in testing function and that’s great. Find some good aftermarket match ammunition and try it. Knowing if it’s ammunition or firearm will save you some money, time and effort. Remember,1911’s like wet lubrication especially if it’s new.

@desertsoldier41 Жыл бұрын

The closest to Norma spec for practice loads is going to be Sig Sauer

@locacarnivore900 Жыл бұрын

I concur. I was so impressed with their 180 grain FMJ load, I think it would make a fair bear load if that's all one could get.

@dickeymoore3662 5 ай бұрын

Did you get this 1911 10mm to run right if so what did you do to get it running right?

@locacarnivore900 5 ай бұрын

After about 120 - 150 rounds it settled down. It's fine with my preferred hollow points and with Federal hard cast. I now trust it as much as any other gun and carry it for bears. Glad to hear from you. Thanks for watching.

@dickeymoore3662 5 ай бұрын

@@locacarnivore900 no problemo Thanks

@craigcook1571 Жыл бұрын

What was the knife in the picture?

@locacarnivore900 Жыл бұрын

Gerber BMF. I think it is out of production.

@craigcook1571 Жыл бұрын

@@locacarnivore900 it is out of production. I couldn’t see the handle so wasn’t sure what it was. It looked more like the knife they came out with during the our time in Somalia. I can’t remember the name of it for sure but think it was called the patriot (I’m probably wrong on that)

@craigcook1571 Жыл бұрын

@@locacarnivore900 I just looked it up, the one I thought it was is the patriot Thanks for the reply

@garretalston1536 11 ай бұрын

7:14 PMC 200 gr FMJ 10mm is garbage. At least it was for me. Totally jammed my Springfield TRP. Choked the heck out of my gun. Maybe Springfield 1911’s don’t like it. Who knows, but I wouldn’t recommend it.