What made you get rid of the cinebot? And what do you think of the the c20 in comparison? Thanks for watching.

Thanks for watching and the feedback as well. I'll be sure to try without music in the future :) As far as I'm aware you don't need RID when the drone is below 250g, and you would also need a module to transmit the location. Which would be quite annoying for a small drone like this where every gram matters. I can't tell the future, but I hope these small drones won't be subjugated to RID. Cheers!

Hey thanks for the feedback. I'll try to either not have music or at least lower it in the future. This is a diy C20 V2, if you buy it you can get it with gps. But I haven't found a use case for a gps on the small drones. Wouldn't use the small ones here for flying over water. For those i would use a 3.5" or larger. I would say i don't think you would gain much by changing from a cinelog20 or a qav to this. Thanks for watching!

Hey, that sounds strange. have you checked the stick input inside betaflgiht at check that they are correct? else you can check blackbox logs, to see if there is anything wrong. if you want help, feel free to reach out via discord, discord name: Raukael

@@RaukFPV Ok thanks I'm go to check it thanks

Hey i am using the freewill filters but they didn't fit either. I had to just make a small cut with an exacto knife. Just just cut off the TPU where it didn't fit. It's a very small amount you have to cut off. Thanks for watching!

@@RaukFPV The TPU guard is removable from the camera. I imagine it would fit fine then.

Hey, first thans for watching!. Unfortunately the dji rc are not compatible with the fpv simulators. The Dji mini 3 pro does have an fpv mode if you have the goggles 2 and the motion controller 2, but its a very different experience. What id recommend, (i have a video in the works that i hope to get to at some point) is that you get a ps or xbox controller, while they are vastly different from normal fpv controllers they can work to get a sense if fpv is the right move for you. If you already know that fpv is for you id recommend getting a decent controller, and depending on what controller you can afford and prefer. here id recommend either of the radiomaster boxer, tx16s or the zorro. Alternately the dji controller 2 is also viable. if you are planning on going dji digital with the fpv drones. For the Simulator id recommend either Liftoff or uncrashed if you want to do freestyle, or Velocidrone if you plan on racing. If you just want to start out and want a free alternative you can get the fpv.skydive whcih is a pretty good simulator as well, but not as good as the paid options. Hope this helps, and feel free to ask any questions you might have.

:D :D :D mange tak!

stock betaflight was 4.3 i updated it to 4.4.2 and matched the old tune via sliders.

im thinking of switching to the gemfan d51-5 like you have to give me more grip and a slower flying craft.

Hey yes, ive done a quite some tuning to it. i am not using stock tunes, and ive flashed bjuejay to my esc. It is still fast for indoor, but that mostly comes down to more throttle control as well as slower rates and the camera angle. another thing i could recommend is adding a throttle limit with scale just to bring down the speed.

@@RaukFPV yep my rates are 300 pitch and roll 200 yaw. But I’ll drop it even more as this is very touchy. Would you be down to share your tune? Mine acts very jumpy in a tight corridor from the air haha

​@@Shokstix sure, just typed the whole thing and youtube decided not to let me post. please write to my discord at Raukael