Долго я искал ответ на этот вопрос

Ну ты мастер! Спасибо

Great. This solved my issue. Subtitles were a bit sketchy. lol I just drove a 4.6T 4.75M box half loaded box sprinter up a mountain at 40km/h in limp mode. Finally now i can use it again. The taco was draining my battery and i killed 2 new batteries over previous the winters so i removed the permanent positive+ from the taco and wired it to the ignition + from the radio. This is when i started to get this issue. I wonder if i will have to reset the taco every time now? I tried to reset limp mode on the truck by turning the ignition on and off 7 times and removing the key but it did not seem to help. Light is out now and it now revs over 3500RPM i was only getting to 2000RPM in 3rd and sometimes 2nd gear on the mountain due to the weight and the steep hill. Phew that was stressful. I had it on the motorway on the way down and that was also a bit stressful but not as bad on the flats. Ps. You don't need any disc in the taco. I don't even own a disc. lol

Крассавчик

Полезная информация

У меня точна такая же машина Попробую тоже так зделать Спасибо мужик Класс и подписка

Красава спасибо))))

👍👍👍

Спасібо

Тоже самое у меня спасибо. Подписка

А он отключится навсегда? Или через время загорится обратно?

Как снять тахограф из панели не подскажите

Ну ты мастер! Спасибо