I only just came across this video, the tool has to be the right way up, once it’s in, pull the sliders back and give the tool a pull, if it moves out at all, it’s upside down. Try again. Once it’s in properly, twist left and right but also up and down, not left and right against the blade but up and down, twist left and right. Usually doesn’t take more than 10 seconds. Good luck, I love these tools 🤞🏼

Does it work only one way or does it go in ether way, are both sides interchangeable

Does it work on just one side or both sides of the pick ?

Are each side interchangeable?

I see that you have the mini prog just sitting there on the side lol. PLS make a video on it when you can.

Have another go and do another video it does work

I have simmilar, black with Mr Li logo, I managed only to open 1 golf5 lock in less than 10 seconds, need to be inserted right way, the oldest won't go. You need to put little pressure left and right and holding in those positions move down and up. I think is only good gen 3 hu66

How to open this cylindar??

Not a reset key but a key to tell you which way round to insert the tool!! When the key goes fully in make sure the dot on the tool is on the same side as the dot on the key. You can also insert the tool, pull the slider then pull the tool, if it comes out 4-5 mm the tool is upside down.

Wher may I purchase this?

When you insert the tool, pull the sliders back, then pull the tool back, if the tool moves back it's the wrong way, turn the tool around then try again

Como eu faço pra comprar

Did you ever get this to work ?

I must admit you had tool wrong way round at 1st !...I have brought the same style hu66 tool , it never opened the lock, always over set some pins pass where they were suppose to be.Also the more I tried the tool started to twist in the handle ...not that good in my opinion

You have the tool in the wrong orientation,The key that comes with it is to let you know which way the tool goes into should have a little dot on the side.

What lock is that? Not from your part of the world, that looks like a Golf Mk7 door lock which would be HU162 not HU66. But your key looks HU66 so I suspect you’re good. But is it HU66 Gen1 or Gen2? The reason I ask is I had trouble with mine until I realized my practise lock was a gen1 HU66. It had up,down,up,down,up,down,up,down wafer configuration rather than the up,up,down,down,up,up,down,down this tool works on. Felt like an idiot but it’s working fine now.

Have another go

Have you tried the vapon katana???

Hope this helps post a new video if you can after you watch video I sent you should have no problem with the tool

👍♥️♥️♥️♥️♥️♥️♥️👍

Have you got it up the right way? It looks like you have to get it set up for the correct wafer configuration up,up,down,down,up,up,down,down NOT down,down,up,up,down,down,up,up

I had the same problem at first. Till I learned it was upside down. Trick is when you turn tool and it pull back its the wrong way round.

La++++

This is a impression tool

That’s really upsetting to buy a tool that doesn’t work...

Одноразовый

I got a refund

BE WARNED. The very first time I used one of these on a customers car it became stuck in the barrel and I struggled for over an hour to remove it. Will never use it again as its ended up in the bin. Very untrustworthy piece of junk

another tool for the junk

Talk waaaaaaaay too much