Hands down, the best breakdown video on KZfaq. I appreciate you sir.

Great video thanks! It really helped me understand what was happening with my dryer.

LMFAO 😂😂 crack "don't break that" best part of the show lol that was great

Can you advise on how to fix the issue of the motor starts and then stop after a few minute

Where do you get lint buildup inside. What side would be best to access?

Hi I hope this is not a completely bizarre question and I'm really really praying that you can write me back I am desperate for any advice my dad cut a hole in the side of the dryer to try to get to the heater because for whatever reason that's how he thought he could access it so he cut a hole in the left side wall of the dryer about 12 by 10 I am now wanting to sell them and it looked so unbelievable that I would rather sell them with it fixed and also thank you so very much for the amazing informative video it is by far the best one that I've seen on KZfaq as far as these dryers and washers go thank you thank you hope to hear back from you soon have a great night

Thank you. Was trying to figure out what the thing was at 35:19. The person who installed dryer connected the external drain kit to this piece of plastic instead of up at the red/orange hose. Yikes

Good job sir

Thanks man !

Super helpful. I have an earlier version of this model (#EFDE 210TIW) which was giving me an intermittent E50 error code. Electrolux service technician replaced the motor but that did not fix the problem. Is there a way to verify if the problem is in the control board (other than purchasing one and replacing it)? Thanks!

Time dry cycle dryer heat up to 155 F and after that temperature stay 122F and does not go more but setting jeans/ What do you think the problem is?