An older video but really helpful. Thanks

This helped a bunch. I hadn't taken off that tip with the wrench Since I bought the darn thing. There was a giant Gray blob of goo clogging in there. Once I got that thing out the whole airbrush works much better. Thank you I also discovered that if you put a little bit of Vaseline on that tiny piston that your airbrush is a lot less likely to get stuck in the spray position. Access a little bit of lubricant between that piston and the internal O ring where the air feeds. Hope that helps.

Thank you heaps for the informative video. Helped me a lot.

Having just bought one in the past month, thank you for the video.

I found this very helpful with my 2nd attempt at stripping down my HP C Plus (I may have used your short one on the first attempt a while back...). I think it would worthwhile covering common problems and how to resolve them. I have spent all night and this morning trying to work out how to resolve a clogged and jammed needle in mine. This vid helped me understand how it should be removed, but I had to trawl google to get advice on how to actually get the needle out...

Thank you that was amazing 👍👍👍👍👍👍

Thank you, this video is great! Hope your lungs are ok

Thank you sir for excellent video. Now I can clean mine properly. It was given to me so I don't know if it's ever been thoroughly cleaned.

Thanks for that. I am hoping this ( brand airbrush) is what I'm getting for my Birthday!

Does any kind of thinner will work for cleaning the airbrush? have you use the createx airbrush cleaner?

for tank and air craft models which is better. this one or IWATA ECLIPSE HP CS?

Drewe Manton is that a good brush for automotive projects?

Ah! Moving Pictures avatar.

I didn't get any lube with mine ...