Installing the Mina Performance Intake, on my 1997 XK8. Here is the link to the part www.minagallery.com/jaguar-xk...
Пікірлер: 48
@hewyn13 жыл бұрын
What a great video and what a great modification! I shall go and search for one right now. Cheers and many thanks from the U.K. Cheers Nick
@timshannon9994 жыл бұрын
Looks fab Geoff. Shouldn’t have watched series out of order!
@ToTheGarage4 жыл бұрын
Love the video Geoff I will be interested in how you get on with bonnet clearance. As you said, it’s going to be tight. Looks much better though 👍👍
@Biggles4 жыл бұрын
Nice, easy little mod. I will be interested to hear what sort of performance gains it gives.
@jameswhite90253 жыл бұрын
on my XJR-100 and XKR I put a Cobrahead elbow in place of the Mina supplied one, much lower profile, same air flow
@gsminors3 жыл бұрын
Thank you for sharing that modification it is worth a look at.
@ambrosemartos64082 жыл бұрын
Hi. Did you have to cut the Cobrahead or the Mina air intake pipe to make it fit? Ihave 1998 XK8
@rockers2rockers616 Жыл бұрын
Do your extractors and exhaust. Remove some of the mufflers leaving just the rear pair of mufflers. You should be able to get bolt on replacement extractors from England. Dyno-Tune her.
@Roscoeverdin54694 жыл бұрын
Geoff, what is your assessment of the intake? Would you do it again? Can you feel a difference in performance?
@gsminors3 жыл бұрын
Good question. K & N air filter for sure. Ask me again later in the year if I would do it again.
@mv-photo2 жыл бұрын
Thanks for the video. Would you recommend it after having it on for a year?
@gsminors2 жыл бұрын
That is a good question. The answer is yes but I would get a different Lower profile elbow at the throttle body end.
@amartosresearch19343 жыл бұрын
Hi again. I am def getting this but am also debating the Mina air filter vs the K&N filter. Mina says the plastic filter box itself is the biggest problem for airflow. Thoughts?
@gsminors3 жыл бұрын
Stick with the original air box it gets cold air forced into it
@amartosresearch19343 жыл бұрын
@@gsminors And the Mina open cone filter doesn't?
@richardsmith95093 жыл бұрын
Geoff: once it was fully installed, did you see any change in performance? How about intake sound?
@gsminors3 жыл бұрын
Hi Richard. The Jag pulls really nice and smooth hard to say if it has improved performance. I do get really good fuel consumption now. No noticeable noise increase, even under hard acceleration.
@malevolenceXXXensues4 жыл бұрын
Does your dash get any codes over that mod? I have to be careful in my state with smog inspection.
@gsminors4 жыл бұрын
No. Been driving it a while now with no problems.
@yuutube73583 жыл бұрын
I want it too.Did your car lose low speed torque by installing this pipe?
@gsminors3 жыл бұрын
None at all. I also fitted a K & N air filter to help it breath better as well. I think it a good option to get a little bit more power.
@amartosresearch19343 жыл бұрын
Hi. How did the hood clearance issue work out?
@gsminors3 жыл бұрын
It is a tight fit but no issues. There is available a lower profile fitting which I am looking into
@grahamwalker63953 жыл бұрын
I was seriously considering this but on another forum, someone raised the point that as it is aluminium it may suffer form heat transfer from the engine bay. The plastic one has a lower coefficient of heat transfer so may be better. Thoughts? I welcome any opinions.
@gsminors3 жыл бұрын
I tend to disagree with that comment as cold air is flowing through the manifold while you are driving. Some conversions I have seen have a open airbox in the engine bay those do not work. I no longer join forums too many opinions and key board warriors.
@grahamwalker63953 жыл бұрын
@@gsminors fair point and I'm inclined to agree, the air doesn't exactly stay in there for long
@drewframson97223 жыл бұрын
Did yours come with installation instructions?
@gsminors3 жыл бұрын
No but it is very easy to install.
@wonderfulworldofWoody4 жыл бұрын
So it’s been a few months now. Was the mod worthwhile? Looks nice...
@gsminors3 жыл бұрын
So far no problems with the install. Engine seems to breath easier and I am getting good fuel consumption.
@amartosresearch19343 жыл бұрын
@@gsminors Hi! Thanks for posting this. Can you share any numbers on fuel consumption improvement?
@gsminors3 жыл бұрын
@@amartosresearch1934 thank you for watching. Fuel consumption I am getting is 9 liters/100km. Highway driving at a decent speed. Seems more responsive when I floor it. Very pleased with the conversion.
@gsminors3 жыл бұрын
Yes very pleased with the conversion.
@gsminors3 жыл бұрын
Yes very pleased with the conversion. No issues to report.