This video walks you through the basic steps for our mounting solution for the SP9100 Switch-Pros system for the Jeep JL and Jeep JT Gladiator. The installation is the same for both vehicles.
If you're looking for something specific, here's a list of jump-to sections in the video:
0:24- What's in the kit
1:16- Affix power module to mounting plate
1:34- Mounted power module on mounting plate and grounding wires
2:01- Battery cable
2:10- Communications cable and demonstration of how to run wires cleanly along cowl area
2:38- Vehicles with a dual battery system
2:54- Connect ignition wire
3:23- Output accessories wires
3:53- Pass communications cable through to cab to touch panel
4:27- Attach white lights wire (allows for dimmable backlighting)
4:52- Remove grab handle to install switch panel
5:24- Drill a hole in the a-pillar for the pass through of switch panel harness
6:03- Pre-assembly of switch panel
6:41- Install switch panel assembly into a-pillar
7:08- Feed white connector from communications cable up through dash to connect with switch panel in cab
7:35- Tighten switch panel after grab handle is in position
7:55- Tighten screws in the back of the switch panel
8:02- Re-install factory hardware
8:20- SP9100 systems and external triggers