Allen Edwards is an expert on John Deere tractors. He’s worked hands on with them for more than 30 years. In this video he explains the basics of how the hydraulic and steering systems operate on the 40 series John Deere tractors.
Пікірлер: 19
@robbiepresley91442 жыл бұрын
Glad you are passing your knowledge on. Thank you sir 🙏
@chrisnzeleni51313 ай бұрын
Very useful interaction thank you so much.
@davidnewell5024 Жыл бұрын
I have a vidio of the noise that it makes. I rebuilt the steering column and put a new hyd pump on the tractor. Did not change or fix it.
@Jamesjghome Жыл бұрын
Very well done, on my 301 the FEL front loader doesn’t work unless three point is up. Is that right?? Love your walk and taking jewels of wisdom
@jbarr355111 ай бұрын
Any idea why an 1120 would chatter the loader & 3pt hitch? not the steering the pressure is 2000psi then drops when in demand. My tank return goes back to the pump...
@johnnyholland8765 Жыл бұрын
I have a early seventies 2020 that has only manual steering. Could this be my problem or did these tractors come with manual steering? Please respond if you read this as I really need to know. Thank you.
@ewaugh693 жыл бұрын
Hey love my 2130. Just finished plowing a field today on it. Thanks for the video very informative. A question about hydraulics, I was trying to run a three point hitch wood splitter. I had the remote lever pulled and worked the splitter back and forth which was fine. After a little use it starts to chatter on me. Still seems to work but chatters and shakes the hydraulic lines. Is that just cause the pump isn't keeping up with the flow demand or something else? Is it ok to run it like that for long periods or would it cause damage? thanks!!!!
@giledwards25192 жыл бұрын
Hi! Sorry for the late reply. Do you happen to know where your return line runs to? It sounds like it runs to the transmission case. If so, you may be running the main pump out of fluid. In later models, they ran the return back to the filter cover (underneath) so that your accessory ports were not limited by the capacity of the return pump which is located in the transmission.
@ewaugh692 жыл бұрын
@@giledwards2519 hey, can't say I know for sure. Worth a look. Either way, is there a risk of damaging something by running it? Thanks a lot of getting back to me!!!
@giledwards25192 жыл бұрын
@@ewaugh69 Shouldn't cause any damage. Just creates undesirable operation. Check those return lines and see if they just dump into the trans case, or if they go into the filter cover. I'll see if I can find a picture of the return line that goes to the filter cover so you can see what to look for!
@dayleerickson45542 жыл бұрын
@@giledwards2519 I have a 1020 John Deere tractor without power steering or hydraulics in the rear. It only has three point hitch. How can I add power steering and hydraulics to the back. How would I do this or where can I find a kit. With instructions. Model 4R10 Year is 1966 I think.
@davidnewell5024 Жыл бұрын
I have an 1120 that chatters the steering when turning it. Do you know what causes this.
@jbarr355111 ай бұрын
i have a 1120 that chatters the loader& 3pt hitch, did you ever figure yours out?
@davidnewell502411 ай бұрын
@jbarr3551 I put a new hyd pump inside the transmission. Quieted it some but that is not the whole problem. Im stompped. Going to run it as is. Unless someone has a fix for it.
@ralphking5428 Жыл бұрын
I have a JD 2355 with hydrauiic problems. My internal transmission pump is not sending the 150 pounds oil pressure to the front high pressure pump. I need to gain access to the internal hydraulic pump, which means splitting my tractor in half. I asked a JD dealer, and they want $3600 to do that. I need to find how to do it for myself. Can you help?
@juanramirez5817 Жыл бұрын
I’m no mechanic but it’s not super hard
@MichaelsJohnDeere3 ай бұрын
You need stands if they told you that you have to split the tractor.
@robertoliver5216 Жыл бұрын
My hydraulic guit working no steering no 3 point ck screen bypass valve new filter no help how to I test the pump