The new Jumperless firmware (1.3.1) can scan the board really quickly (~100 times per second) to look for the PWM signal coming from the probe. So now you can just poke out the connections you want to make and the Jumperless will make them into real hardware connections. No computer required.
You don't even need to make a probe like I did here, a piece of wire shoved into GPIO 19 will work too. And you just tap the wire to GPIO 18 to act as the button.
Near the end I'm clearing the connections by holding down the BOOT button, you can also double tap BOOT to load the last circuit you made.
You can get a Jumperless here:
www.tindie.com/products/archi...
Or talk about them on the Discord:
/ discord