This shows how much you can learn from your mistakes
@wschevyrider5 ай бұрын
Best video on raptor liner I've seen so far
@michealbell3485 Жыл бұрын
TY,…I was about to just mix my four bottles then go tape my truck bed 😂
@KekeeBlack Жыл бұрын
In general, anything you have to mix, use it immediately and as quickly as possible. They are separated for a reason. Esp if one bottle is labelled “hardener” lol. And I always wear steel toes when doing anything DIY related. If I dropped a bolt on my toe I’d probably cry! 😂
@whatsupmanbearpig Жыл бұрын
ALWAYS USE A RESPIRATOR rated for it. ALWAYS read the MSDS.
@Meatwad.Baggins Жыл бұрын
And TDS
@sandslinger6720 Жыл бұрын
That looks like a job where coors in mandatory!
@Meatwad.Baggins Жыл бұрын
Was drinkin coors before it was cool
@bigospig3 ай бұрын
If only Raptor Liner included instructions.
@tooswaee18019 ай бұрын
This was funny asf😂
@Dan-ez6dr2 ай бұрын
This explains why they don't sell DIY surgery kits.
@Pozzer5286 ай бұрын
😂 I would have worn flip flops too 😂
@jedmassey Жыл бұрын
Good tips aaaand of course I'm going with the coors option
@3minitruck Жыл бұрын
Ok I’m still gonna wear flip flops
@MrElbory3603 ай бұрын
Thanks for the advice. I'm about to Raptor liner my jeep 🚙.
@migrant8443Ай бұрын
Thanks
@MegaTapdog Жыл бұрын
Just a tip, read the instructions and understand the product. 😂
@CCRIDER-wq4hmАй бұрын
Dude I'm looking at my material right now, and I'm like fuck this is gonna be a pain in the ass.
@chrisblum814025 күн бұрын
Coors is a must
@tootallreggie8 ай бұрын
Thanks bro.
@justathought88 Жыл бұрын
Maybe hold off on the beer until after you're done with your project?
@gzus1482 Жыл бұрын
Or at least cover the top. 😂😂😂
@KekeeBlack Жыл бұрын
My bev of choice when working is Heineken NA! Not sure if the make NA Coors but it would be good!
@ballygarran2 ай бұрын
Thanks for the info about shelf life.
@AL-qr4vf Жыл бұрын
Lmao! Thanks bro
@SolarMillUSA4 ай бұрын
That’s not caustic 🙃 (caustic is pH with an alkalinity high enough to be corrosive). that’s just a strong solvent but it really doesn’t take much to dissolve a solo cup, those are basically good for latex paint and that’s about it. Basic nail polish remover acetone will melt write through them. And it’s not an epoxy finish, it’s a urethane. But it is a 2K urethane that does have a “pot life”
@codyproctor334611 ай бұрын
There should be no measuring. There’s an indention on the bottle you fill the hardner to. Just use a flashlight to make sure you don’t overfill. My hands and legs looked the same lol
@dbc1052 ай бұрын
And 5, Drink Lite Beer from Miller!
@dennisjump8655 Жыл бұрын
I would also add that if you're using the tintable, add the paint and liner and hardener in a separate cup, not the bottle. It will overfill, like it did on me.
@KissiPreston2 ай бұрын
Hahaha omg this video made me laugh.
@smokeythehuman3596 Жыл бұрын
Never used raptor line but used I think it's bullyliner at Walmart it's waterbased but hard to get off of skin
@thomasjustice5364Ай бұрын
Throw the bottle in the fridge to slow down the hardening process. It’ll buy you a few more hours with it
@freerangejimboАй бұрын
Really? I did not think to try that.
@thomasjustice5364Ай бұрын
@@freerangejimbo you can do it with any catalyzed product. Primer, sealer, filler, clear, ect.
@ace1c878 Жыл бұрын
Idk when I'll use this info but thank you
@darbymcbride41 Жыл бұрын
Coors optional. Very nice ;)
@dangerdiesel310611 ай бұрын
NO SIR!!! Coors is mandatory
@josal5557 Жыл бұрын
Don't drink and Raptor at the same time
@brianduran654711 ай бұрын
Coors is mandatory!
@alphacreatorsmedia4 ай бұрын
I had flip flops right now 😂😂😂
@richardguillory46316 күн бұрын
I was waiting for “3, wear underwear” 😂🤷🏻♂️
@damianandlogan55116 ай бұрын
Coots IS NOT optional pal. It's mandatory.
@Ksix1Ай бұрын
Coors is never optional lmao
@mojo65247 ай бұрын
never take instructions from someone that doesn't know that catalyzed epoxy will set up in the bottle
@virginiacastillo8839 ай бұрын
Taking my sandals of rn 😂
@monreal9944 Жыл бұрын
No Sir, coors is a must!!!!
@baltimoredrummer1 Жыл бұрын
How many times did you mistake the bedliner for your #coorslight?
@Jay3884 ай бұрын
Just get the spray can 😂
@Spectrum_Auto_SpaАй бұрын
How did the running boards turn out. I'm thinking of buying the spray cans for my running boards. I think one can each should do
@freerangejimboАй бұрын
All good after about a year and a half. I’d suggest getting a spare can, just in case.
@moejr14 Жыл бұрын
Thank you for answering my question. I wanted to know if it could be stored after added the hardener? I guess not. How many bottle did it take you to get a nice coat on your running boards?
@freerangejimbo Жыл бұрын
Actual amount used was about 2.5 qts. Plus .5 qt wasted because I left it mixed, plus 1 qt useless because the hardener for it ate through my plastic cup and spilled. So, with waste, a full gallon kit. If you do this, after you use the first bottle, I'd recommend saving the empty. You can use it to mix partial batches as needed. Note that these are some big running boards, like 10ft long, so they had a lot of surface to cover. I used 6 qts to do the 8 ft bed on the truck.
@morganuser6817 Жыл бұрын
You forgot mistake number five, never slam down too many of those Coors lights before you go and try to do something you've never done before. 🤣😂🤣😂🤣😂
@foleydave26 Жыл бұрын
Lol probably read the directions before you start. But thanks for the tips buddy
@pourtierbeatz780410 ай бұрын
Mone dried up faster then expected too idk how u can even cover a whole truck bed without it drying soo fast :/
@freerangejimbo10 ай бұрын
Like dried up in the bottle? Were you mixing more than one bottle at once?
@pourtierbeatz780410 ай бұрын
Yeah literally dried up in the bottle with the cap closed i literally followed the instructions i put in of those hardeners in there and shook
@mermaidvanvb8 ай бұрын
How did you clean the sprayer between bottles? So it didn't harden on you
@freerangejimbo8 ай бұрын
I put the sprayer straw into a glass filled with acetone. Then I sprayed it onto my driveway until it ran clear.
@mermaidvanvb8 ай бұрын
@@freerangejimbo thx- that's kinda what I did yesterday
@frankrosemeck98983 ай бұрын
Flip flops are not sandals...
@tootallreggie8 ай бұрын
Next time measure with the coors can.
@freerangejimbo8 ай бұрын
solid advice
@drewstanley8720 Жыл бұрын
I can see the fumes in the video
@TheMrjetdoc358 ай бұрын
Id image also wear a respirator.
@evanlucas87346 ай бұрын
What kind of
@eason9115 Жыл бұрын
Well atleast you got a coors could be worse!
@Bottomfeedercustoms20244 ай бұрын
Coors is not optional. Lol
@brotherjohn7762 Жыл бұрын
Yeah maybe I’m old-school, but the only time I walk out to my shop with flip-flops on is when I forgot and left a light on. You younger guys probably have not met a lot of people missing toes and fingers because they weren’t protected. 😮 Just saying don’t be mad at me I’m trying to save you a visit to the hospital.
@freerangejimbo Жыл бұрын
You’re not wrong, but I’m stubborn, with fresh stitches in my hand to prove it.
@tomcronininc11 ай бұрын
Hahaha
@scor440 Жыл бұрын
And never never ever follow the instructions!
@khg85199 ай бұрын
I'm a professional too
@meyscobos2417Ай бұрын
This video came a week too late bud
@ozman65256 ай бұрын
Talk about stupidity…
@stephenjones40139 ай бұрын
Stay in school
@scotty7243 Жыл бұрын
This shows drinking coors is stupid choice number 1.