Kawasaki Mule Driveshaft CV Boot Replacement

Рет қаралды 20,271

4 жыл бұрын

Replacement of front driveshaft CV boot on Kawasaki Mule.
Thanks for watching
Website: www.twocylindervintage.com
Facebook: / twocylindervi. .
See more videos and Subscribe at: / twocylindervin. .
This video is only a guide, repairs to your vehicle should always be carried out my a qualified mechanic using workshop manual and follow all safety guidelines.

Пікірлер: 16

@williamkinney5019 4 ай бұрын

Will use this video as guide for my 2001 2510. Thanks

@MrCarmelo1959 11 ай бұрын

Nice work thanks I was thinking on replacing the whole axle but now I’m going to check it before ordering any parts thanks

@farmlife5763 3 жыл бұрын

I am also a new owner of a older Kawasaki Mule, when I bought it from my friend I knew it needed both boots replaced, this is a great video, looks so easy to replace them.. Thank you

@TwoCylinderVintage 3 жыл бұрын

Thank you. Hope it is helpful and as easy as it looks.

@kontarbriggs495 Жыл бұрын

your video helped me change my cv boot. Thanks for uploading.

@kevinburgess6112 3 жыл бұрын

new subscriber, as a mule owner i really appreciate the great video, thank you 👍👍

@TwoCylinderVintage 3 жыл бұрын

Kevin Burgess thanks Kevin. Have fun with your mule.

@PRSH8YAPROJECTS 2 жыл бұрын

Just the video I needed

@jeremiahballard2414 3 жыл бұрын

Great video! Thanks a ton!

@TwoCylinderVintage 3 жыл бұрын

Glad it was helpful!

@timdundas5969 2 жыл бұрын

Great video. Could you specify which models share this same assembly? I have removed the drive shaft assembly but am unable to separate the shaft from the outer ball-race. My Mule is a KAF620E vintage 2003 I believe.

@TwoCylinderVintage 2 жыл бұрын

Not sure on what other models. usually CV joints are very similar and will have either s circlip or will hit off with hammer. might pay to get a workshop manual specific to your vehicle.

@oneloveyessah 2 жыл бұрын

I followed your video but I'm having problems getting the hub/rotor back on. Something is stopping it from sliding back on the akle. Any idea?

@TwoCylinderVintage 2 жыл бұрын

I had a little trouble with this too. Cut out a lot of footage as it took a little to get on. Check that the hub is not getting jammed on the brake shoes. Back off adjustment. Make sure the spline is clean. By memory it was a tight fit.