Excellent troubleshooting school right here in this video !!! Well done. 👏👏👏👏👏

Dude amazing videos. Part 1 and part 2 extremely great information. You are the man, and a great teacher. Wish you had a shop in Florida. I do all my own repairs on my 2001 2500 because I’ve had no luck trusting anybody here. I am not a mechanic, I’m a machinist so I don’t work on vehicles all the time so thank you for the great videos. 👍 subscribed and liked. 🤘

First thing I'm going to do is get this piece of spring in shrink wrap and make me couple of those little pinion search put in the why are there that's awesome thank you and your advice you was spot-on I believe I'll be able to find my problem now

I never knew you could test ground like that. Thank you

Another outstanding video. I am eagerly anticipating the second part. I wish you were in my area, you would be my go to mechanic hands down.

Very good

What a great video. You, sir, are an awesome teacher. Liked and Subscribed.

Wow! Outstanding video. Great job explaining and showing what you're doing. 👏

I have been loocking for a good youtube video regarding .abs sistem on my 99 dodge ram . and yours is awsome . I have not seen any body doing susch good explanation , thanks a lot , you have a new suscriber , by the way if it is posible can you tel me if it is possible to check the abs sensors on a 1999 dodge ram 3500 ,24V cummins with a multimeter ,I have try but it does'nt read any resistance ,again thanks a lot keep going you do great.

Awesome set of videos. What does it mean if the waveform is the same after disconnecting the harness from the module? I still get the bad bump whether the harness is connected or disconnected. My abs and brake light are on. Still getting speedometer from rear sensor. So i think rear sensor is good.

Thank you very much, learned a lot from your video!

I'm curious as to how you became so knowledgeable of the can bus system, I'd really like to start diving into it more and have a better understanding. Any tips on where I should begin? Greatly appreciated!

Helpful video. Thank you for taking the time make it.

That was very special for a vedeo

more and more videos like this

Nice job bro 👍

Hi my friend have the same problem with my 98 dodge ram 2500 V10 the ABS module part#5013902AA is not available can you help me try to find one or where can I go thanks for everything

This is the Kelsey-Hayes EBC 325 ABS. If you have two upside down solenoids on top (looks like two carburetor bowls) then you have Kelsey-Hayes EBC 2 ABS.

Excellent video!!

Well I have ABS light on. But my scanner doesn't show a code. So there could be a problem with communication. I can't afford a scanner is nice as yours so I don't have a wiring diagram. And I can't afford the dealer. I guess I'm going to have to live with it!

Hi i have a 97 dodge ram 2500 turbo disel 5.9 cummins my problem is that my RPM needle keeps bouncing alot and my turbo doesn't kick in when i reach 40 mph and i kind losses power at that speed any ideas.

I have the same problem and brought an autel maxicom but does not scan my 99, what scanner tool are you using?

Bien joué frérot !

Is it hard to install a abs module?

Hi, I just replaced an abs module on my ram 1500 and need to program the new one to match my vehicle vin any advice?

What kind of scanner do you have ? Thank

👍🌷🌷🌷

Are you teaching Ivan diagnostics?

The brake light is on

What kind of scan tool do u have

My truck made a violent braking when is cold

That was a resume

Hello did you see my post below? vvvvvv