You're not doing anything except using the pen. The knife blade still does not work.

They need to ban mimes from making KZfaq videos.🤣

So many people are having the deep blade not being detected when starting a new cut issue. Well I was starting to think same thing after about an hour of messing with it. If you are having a problem with it getting stuck at the blade detection screen it's because you are choosing the wrong material! Try choosing a thicker/heavier material which will automatically choose the correct blade and it WILL work. I learned this the hard way but once I figured out what was going on it immediately worked fine and cut beautifully through some 1/16" silicone rubber sheet. You may need to keep choosing a different material to get everything to work right and the right amount of passes. Cricut needs to address this on their site and also within the software! I would prefer they just let me choose what blade I want and how many passes it makes, but apparently it's connected to the material type which is pretty dumb.

The little shine part justo after de Blade si not clean, usually with finger prints, justo clean that part and Will work, it happened to me.

Wth even is this? You do realize that your audience is most likely frustrated that they’re receiving this error msg. If I were you I’d take this worthless video down and start over. Maybe speak. 🤦🏻‍♀️

What have you explained?

im still confused

Useless waste of time