Thank you. I put it all together to find it leaking. Watched your video and realized I had not installed the plastic friction gasket in the right place. Thanks again for this video.

9/16 wrench key point for the tank bolts...you da man! Thank you so much!

Hey Tim! I had to remove a Kohler tank to replace wall paper. The toilet is about 1 yr old, AKA late 2020, and the 3 tank nuts are now 1/2 inch. Your video was very helpful. ThanX!

Good Morning Tim, One thing good? It was inside! Have a good day and it's Friday! Then you have your WEEKEND!

Great video Tim! Have a good weekend.

thank you! I could not find part 1?

You didn’t show the secondary tank -to-base gasket that goes over the large white nut.

I want to change my Kohler canister flush valve with a standard fill tube and flapper...

Do the bolts in toilet need to go all the way down inside tank? I have same toilet and replaced the flush valve but the bolts don't go all the way down so is that normal?

Nice job. Could you have used a regular 2 inch flush valve?

Kohler trying to reinvent the wheel.

How do u get the screws into those grommets?

*what about the rubber gasket? the three gasket lugs or cylinders, inside the tank, stand up past the bottom of the tank about a half inch. does that get cut? will the compress crooked and leak. what a lousy system*

Nice

I'm not impressed with the flush power on this set up. I understand there's a TURBO FLUSH set up.

That bowl looked like crap Tim, you should have informed management to clean it or replace it before renting the room OUT!!!!!!!!