Right up my alley , Down to the cold weather axle oil. The video and pointers are always made simple and are the best out there
@TractorTech6 жыл бұрын
Thanks, I appreciate good feedback.
@marclussier22756 жыл бұрын
Hey Roger, Job well done on the front axle oil change. Take care my friend and have a great week. May God Bless and Protect you and your family Brother. 🤠🚜🇺🇸
@TractorTech6 жыл бұрын
Thanks Marc! God Bless!
@houndsmanone45636 жыл бұрын
Very informative, Roger. I learn a lot watching you do your maintenance. Thanks for the video and say hey to dad (smile). Remember, I told you he'd be a star but I remember you said he doesn't like being in the vids (smile). Have a great week.
@TractorTech6 жыл бұрын
Thanks! He doesn't mind being in the videos.
@rayeddy5286 жыл бұрын
Good job Roger ! I appreciate you doing this video!! Be safe my friend and God bless you and your family !!!!!! Eddy. I always look forward to seeing a new video from you !!
@TractorTech6 жыл бұрын
Thanks Eddy! God bless!
@MillGapFarms3 жыл бұрын
Good video! Thanks for posting it!
@TractorTech3 жыл бұрын
Glad you enjoyed it!
@brwadabrown433 жыл бұрын
Very good explanation. Thanks.
@TractorTech3 жыл бұрын
You are welcome!
@jnichols34 жыл бұрын
Thanks. I am about to do my L3901HST. I assume that the procedure is the same.
@TractorTech4 жыл бұрын
Yes, the process is the same.
@lsxjunkie3 жыл бұрын
I need to find a pump like that. Thanks for the video.
@TractorTech3 жыл бұрын
Here is one:www.amazon.com/Lumax-LX-1300-Lever-Action-Bucket-Gallon/dp/B000MCXOPO/ref=sr_1_5?dchild=1&keywords=Pump+for+5+Gallon+Drum&qid=1604884151&sr=8-5
@lsxjunkie3 жыл бұрын
@@TractorTech thanks man. Do you have a video on the Hydraulic fluid and filter service on the Kubota L series? I have a L4600DT. I need to do mine. It would be nice to have a video of all the fluid drain and fill locations and grease points too. Thanks for your help
@itsamadmadhomestead9733 жыл бұрын
@@lsxjunkie Great request.... I just did my Grand L 3560 400 Hour service that required 2 hydraulic filters, an engine oil filter, full Hydraulic oil changeover, and a fuel filter. That should be up on the Homestead page within the next week or so. Don
@toddrabb18923 жыл бұрын
Great video!! Just what I needed!! Thanks so much for taking the time!
@TractorTech3 жыл бұрын
You are so welcome!
@WallsBeeMan5 жыл бұрын
Very good. got to the point
@TractorTech5 жыл бұрын
Thanks.
@FarmallFanatic6 жыл бұрын
Excellent video 👍
@TractorTech6 жыл бұрын
Thanks!
@toddrabb18923 жыл бұрын
👍👍👍. Thanks for posting!!
@TractorTech3 жыл бұрын
No problem 👍
@abramavila53454 жыл бұрын
Quick question @tractor tech Do you have to add oil to both sides or just one ?
@TractorTech4 жыл бұрын
You put oil in one side and it runs over to the other side.
@itsamadmadhomestead9733 жыл бұрын
Great Question... I found only 1 fill point and it was on the left (drivers) side of the axle. What I found on my Grand L 3560, the oil would actually pour out of the oil level check point when filling if its not installed. The other issue is that it takes time for the oil to flow from the left side to the right down through the axle. If you check the level before this happens, the level will eventually be lower than it should be. I also used the amount of oil specified from the Service Manual, and while adding that much oil took the level just above the fill level indicator, I was comfortable with that.
@ddsgala44056 жыл бұрын
Good video
@TractorTech6 жыл бұрын
Thanks Don!
@lsxjunkie4 жыл бұрын
So you fill with 80/90? How much does it take?
@TractorTech4 жыл бұрын
Yes, I used gear oil. I can't remember the capacity.
@Jlayism5 жыл бұрын
Great video. Question: on the HST kubotas, is the front axle fluid separate from rest of the system? So the 80/90 wouldn't mix with the UDT2?
@TractorTech5 жыл бұрын
Thanks, the front axle is separate. The fluids from it will not mix with anything else.
@Jlayism5 жыл бұрын
@@TractorTech Thanks. Got her back together today. I appreciate the help.
@FromSteelToWood6 жыл бұрын
Thanks for sharing!
@TractorTech6 жыл бұрын
Thanks Joe!
@motocephalic4 жыл бұрын
great video, thanks for posting!
@TractorTech4 жыл бұрын
Your welcome!
@motocephalic4 жыл бұрын
@@TractorTech there was a little more than a quart of gear oil in my front end from a new tractor, less than 400 hours. I was a little concerned. I have rad many posts of front axles being low, but not this much.