Dismantling a damaged Land Rover Lt 230 tranfer box, - Q SUFFIX(stands for quiet - later type units) swapping casings and shimming the beast correctly.
Пікірлер: 11
@MrBadvok Жыл бұрын
Brilliant guide and love the workshop!
@heritagesteel1976 Жыл бұрын
thank you!
@gilesblackie8 ай бұрын
Great video, thanks for putting the time in to make it!
@heritagesteel19768 ай бұрын
And thank you for taking the time to watch. Shared knowledge goes a long way:)
@blackbirdradiomusic10 ай бұрын
Thanks for this. Great breakdown!
@PHARDK4 ай бұрын
Very informative! Thank you very much
@heritagesteel19764 ай бұрын
thank you for watching!
@djwaxstyles1Ай бұрын
I have a question about the hi/low selector shaft. Does the detent ball that holds the slider shaft in gear get held in by the detent is the shaft? In short is the hole that the detent ball and spring go into machined in a way that the ball can't drop into the transfer case? Or does the slider shaft the only thing holding it from falling in the transfer case?
@jameskerr575610 ай бұрын
Great video. Feeling a bit overwhelmed at the minute as I've got a very noisy LT85 split case box (22c) and I've just acquired a used LT85 solid case box (together with an LT230) which I thought I could change out my split case box with. I separated the box and transfer box the other day to find the output shaft splines very worn on the acquired box, which has unfortunately more or less rendered it scrap without a significant rebuild. The box itself feels quite nice but I haven't heard it run. So, do I get my split case rebuilt (still in the vehicle atm) or go for the solid case rebuild? I heard that the solid cases are the stronger box. I believe the bell housing on the split case does fit the solid case box etc.
@heritagesteel197610 ай бұрын
Hi. I personally wouldnt rebuild a LT85. I would go straight to Ashcroft transmissions. If you never did one of those before you will go nuts. They suffer all the same output shaft spline wear because the input gear on the transfer box was not drilled to let oil in. You have to fully rebuild the gearboxe and get a new input gear for the LT230. Its a MAJOR job. I cannot comment on the differences of the LT85 as i rarely see them over here.
@jameskerr575610 ай бұрын
@@heritagesteel1976 Thank you very much for getting back to me with your advice. Much appreciated.