We Dyno The 2024 Mustang GT K&N Intake + Compare to Carbon Trap Delete & High Flow Drop-in Filters

Рет қаралды 12,711

Күн бұрын

In this video, we compare different intake mods against the K&N CAI System!
We dyno our 2024 Mustang GT with a 10R80 transmission and resonator delete. We will be comparing the stock cold air intake with carbon traps on, and then off. Against a high-flow drop-in air filter without the carbon traps. Finally the results with K&N Cold Air Intake without carbon traps. We were surprised, to say the least by the outcome. Tune in to see the results. Let us know what you think in the comments below, and thanks for watching!
Product Links
2024 Mustang K&N Cold Air Intake System: lmr.parts/KN-693541TC
2024 Mustang K&N Drop-in Filter Kit: lmr.parts/KN-RU1037-K
2024 Mustang K&N Drop-In Replacement Air Filter: lmr.parts/LRS-RU1037
Resonator Delete X-pipe: lmr.parts/LRS-5251A
Watch
2024 Mustang GT Stock Dyno Run - • 2024 Mustang GT Dyno! ...
Chapters
00:00 - Intro Explaining The Different Runs & Comparisons
01:21 - Stock Run
01:41 - Removing Carbon Traps
02:10 - No Carbon Traps Run
02:26 - High Flow Filter Install
03:40 - High Flow Filter/ No Carbon Traps Run
03:56 - Stock Air Box Removal
05:21 - K&N Cold Air Intake Install
06:28 - K&N Cold Air Intake Thoughts
07:01 - K&N CAI Run
07:19 - Explanation Of Our Dyno Runs / Windspeeds
08:41 - Dyno Results
13:04 - Final Thoughts
Social
KZfaq: / latemodelrestoration
Facebook: / latemodelresto
Instagram: / latemodelresto
TikTok: / latemodelresto
#lmr #s650mustang #dyno
Use of this video is subject to the terms as set forth in our LMR Install Video Disclaimer | lmr.com/page/lmr-install-vide...

Пікірлер: 48

@mec912 2 күн бұрын

I am very happy you left the pizza bite/bagel/pocket discussion in the video. I was already enjoying the video, but that made me SMILE.

@zeekfarrongaming5302 Ай бұрын

Man I just could not justify spending that amount of money for the cold air intake just to make 10hp. I chose to go with the Steeda drop in filters with carbon traps removed and that was a noticeable difference

@terminatorcoyote6319 2 ай бұрын

Like the transparency and just proofs what we know

@appleiphone69 Ай бұрын

And the K&N adds more grit and dirt into the engine then stock.

@logicbewithyou111 Ай бұрын

not really. they have filters for a reason.

@E85_STI 19 күн бұрын

So the micron filtration does give a little for the amount of air flow but it’s not enough to cause an issue. The biggest thing in the intake filters is bugs and debris from the road so that’s usually on the bottom of the stock intake box when you change the filter and or clean it.

@jacobnolan41 13 күн бұрын

So moral of the story, dont waste my money on this CAI. Got it.

@NITROUSnBIASPLYS Ай бұрын

Good to see honest dyno runs all done the same day and with controlled variables as much as possible

@commycomentor9695 2 ай бұрын

Great job! Just the kind of info I was looking for.

@LongStroke351 2 ай бұрын

Closed hood would not matter with the first 3 pulls since the lid is on the box. Pull the lids of the first 3 pulls.

@nicktobias9661 Ай бұрын

Great video !!!

@gloisma Ай бұрын

nice video, wish everyone made them like this 👌

@sergebasque8460 2 ай бұрын

Well done Landon.😊

@latemodelrestoration Ай бұрын

Thanks. -Landan

@SHADOWBLACKs650 2 ай бұрын

The volume of air with two giant throttle bodies is more than you would have ever had with the last single throttle body, taking out the carbon Traps is messing with a beautiful drivability that the car has for zero benefit, and the K&N intake is letting 200° engine heat into the motor ,unlike the Factory closed box cool ram air..

@hpkntnw 2 ай бұрын

From what I understand only one throttle body opens at part throttle. The only time they both open is at WOT.

@SHADOWBLACKs650 2 ай бұрын

@hpkntnw I don't know but the throttle response is nice, a big difference from my 21 and I had the Ford Motorsports performance pack recalibration and cold air intake from the Shelby, the car is getting enough air.... those stupid traps I think do more for controlling the air flow for the air meter than people realize.... and by now we all know closed air boxes are better for keeping temperatures down, the factory is giving us a nice Ram Air setup and you can kiss that goodbye with any open air box.

@hpkntnw 2 ай бұрын

@@SHADOWBLACKs650I agree I have a 21 Mach 1 that ford spent millions developing a cold air intake for and besides a high flow filter I’m not touching it. I thought of upgrading to a 24 but I’d want the tremec that’s in my Mach 1 and the only way to do that is a dark horse which are crazy money, make minimally more power and are 150-200 lbs heavier not to mention I bought my Mach 1 for $58,000 and only have 16K left on the note with 16,000 miles. I’ve seen the dark horse as high as $100,000 no thanks. I put the handling pack wheels on and it will carve up a road and stop on a dime.

@thee_HK47 Ай бұрын

The moral of the story that I understand is this: buy a procharger and gain a ton of horsies and get the whistle whistle.

@hawkstringfellow Ай бұрын

Do suspension limit slip and great tires for grip call it a day

@willisbreakfield1686 Ай бұрын

Do it with the filter box cover off i think their wil be gains

@Subarashii-naniii 2 ай бұрын

14 minutes vid from LMR on the s650, I’m all here for it.

@donnyfulton6893 Ай бұрын

Would like to see a pull with the typhoon kit and S&B filters.

@latemodelrestoration Ай бұрын

There isn't enough difference in filter density to make it worthwhile. If for some reason there was any difference, it would be very small. At any given point, you have to take into account small dyno variances between runs, ambient conditions, or air flow from fans. A better test for something like that would be to test the flow via cfm. -Landan

@commonsensecatholics Ай бұрын

Its only cold air with the hood open..close the hood and run the dyno and youre pulling hot air in..drop in HP

@Carl-gd1st Ай бұрын

255 series tire are on the small side 285-305's is more like it for the GT.

@hawkstringfellow Ай бұрын

You want power supercharger kit call it a day

@willisbreakfield1686 Ай бұрын

Baby cheat code if one can’t afford the open air filter an intake upgrade

@midlothianstang Ай бұрын

$700 for 14 hp does not really seem worth the money

@Carlos.Rivera Ай бұрын

Better get a dyno tune

@midlothianstang Ай бұрын

@@Carlos.Rivera if only those were available

@michaelthompson4178 2 ай бұрын

This shit looks like my Kia Stinger gt, which also has 2 intakes but it has 2 turbos. The AEM intakes i have basically is to heartye turbo sound, which is super quiet from factory. Seems unnecessary to have 2 throttle bodies on this car. One has been sufficient on basically every V8 car for how long? Single blade flows pretty good on my gen 2 ⚡.

@Lifeof728 Ай бұрын

Umm not every V8 car. There are V8s with dual throttle bodies and dual intake plenums, ITBs and you can kinda call multiple carbs "throttle bodies"...

@michaelthompson4178 Ай бұрын

@@Lifeof728 I was referring to more modern stuff but yeah, your right 👍🏾

@ClickbaitMotorsports Ай бұрын

Basically Ford tried to fix the issue of having the carbon trap mandated from the EPA. The dual-TBs are pretty ridiculous since it goes into a single bank. Ford is targeting ignorant Gen Zers with all these S650 gimmicks, so it makes more sense for marketing.

@Lifeof728 2 ай бұрын

K&N be lyinnnn 😂

@SHADOWBLACKs650 2 ай бұрын

In fact it was the lowest number today on the dyno.

@not1but2and37 Ай бұрын

Yup. It's just foh sho! The low restriction filters work though.

@HSE2inc Ай бұрын

Except the conclusion reached in the video says otherwise. Pretty darn close was the verdict.

@AJS24DH Ай бұрын

Just my opinion and thoughts …. The K&N heat soaks the crap out of that motor . I have never been a fan of aftermarket cold air intakes. To each their own 👍🏻 just not for me.

@HSE2inc Ай бұрын

You didn't hear him explain that the bonnet closed with a fan too.small to replicate the correct airspeed the car sees under motion, heat soak will happen. It was the only run done with the bonnet closed.

@AJS24DH Ай бұрын

@@HSE2inc like I said I’m not a fan of aftermarket cold air intakes . I heard him and it still doesn’t change my mind … lol 😂 I’m definitely not a fan of anything K&N …. The only one that I would remotely consider would be the Roush system and it’s a closed system with a lid but it’s not available for a S650 so it’ll be stock for now .

@willisbreakfield1686 Ай бұрын

It’s being reduce upon the cover high end cars DONT carry that or race cars f almost any sort what u think about yet maybe risking filter to get dirty quicker

@antz19coyote73 2 ай бұрын

😂

@93notchback 2 ай бұрын

Ford Engineers know better. Sorry, but not sorry.

@GoGoggansGo Ай бұрын

Yes and no it’s more of a cost thing too the hot ticket would be high flow intakes pipe retain the stock airboxes and run a high flow filter K&N is hot garbage IMO

@Sheepleton 11 күн бұрын

The same Ford engineers that designed their pos garbage transmissions that literally led to the deaths of the focus and fiesta? Those engineers? Ford builds garbage...

@antz19coyote73 2 ай бұрын

Motto of the story stick to a 18-23 Car and K&N is junk. And if anybody actually believes that Dyno sheet they put in the Box I have a few Bridges for sale for ya.