We talk about chucks, drive spurs, face plates, tool rests, live centers, and more!
Пікірлер: 18
@cyrilnorrie84503 жыл бұрын
Thanks for your easy to understand explanations of the various accessories. This is very helpful.
@stadenart Жыл бұрын
Bill, thanks for this and your other videos for beginner woodturners. Woodturning, like any other worthwhile endeavor, is complex and has a language and toolset all its own. You dispel the mystery out by providing simple, understandable information. Thanks for taking the time.
@entertainmentlyw96893 жыл бұрын
Extremely grateful for this video!!!! Im very interested in getting one lathe for some woodwork projects but idk where to start and have 0 knowledge about it! God bless u man🙏🏻
@davidanderson5767 Жыл бұрын
Getting first lathe. Thank you for these videos.
@attilakovacs5803 Жыл бұрын
Nice lesson, just what I needed, thank you!👍
@nadavshaham95302 жыл бұрын
Thank you for sharing such useful information!
@jaredbalis2 жыл бұрын
Great video. Thanks!
@johnfritz37922 жыл бұрын
Very good video!! Thank you
@tonytunnell98732 жыл бұрын
Thank you so much for this video
@anthonywstanton2 жыл бұрын
Thank you for the informative content sir!
@dennismitchell52767 ай бұрын
Vacuum chuck. I was thinking spending $600.00 dollars in accessories for my $600.00 used lathe just sucks, then you proved it. I appreciate the introduction. I'm a professional woodworker, but wood turning is a whole new language.
@victoryak863 ай бұрын
Those tool rests with the curves for getting inside a bowl: a bit confused in that the curves on the ones shown were on the left as you face the lathe. How would you get inside a bowl on the headstock side? All the bowl hollowing I’ve seen is on the tail stock end. Am I missing something?
@matthewwysocki50195 ай бұрын
Informative! Thanks. Would you be willing to address turning tools needed. Blessings!
@quadcitieswoodturners64165 ай бұрын
Yes, made a series of videos for the beginner. Here is the turning tools video. kzfaq.info/get/bejne/fs5habegmq7Sfac.html
@MrPete1x2 жыл бұрын
Not every lathe comes with a knock out bar. It only takes a few minutes to change chuck jaws. A tray on the bed bars will catch any dropped screws. Screws in a face plate will not waste wood because once a tenon or recess is formed the blank of wood can be reversed and turned into a bowl. A great video, thanks
@redwoodworking Жыл бұрын
How do you find accessories for a lathe that has no markings on it, I purchased it from someone that didn't know anything about it