Yes

Unfortunately no 😢

What’s a slos?

​@@sailingfromswitzerland my god i must had been drunk, "Nice, i would love to see a guided tour from inside this boat, seems to be a intresting ship" =P

Damage, Inc. Hahaha, I know. If you saw the end, then I did explain I’d be back for a part 2, and then I had a bad motorcycle accident. Life happens. Just waiting to heal to go up the mast and continue. What kind of boat do you have? Have you installed lazy jacks? Thanks

Hope you heal soon. Would like to see the part 2

Thank you. Buddy and I are both doing well. Greetings to you and Kira! I never actually finished installing them because I don’t have the equipment to climb the mast. I’m just missing two attachment points about 2/3 up the mast, and they’re identical to the ones I added at the bottom of the mast. Once done, I guess part 2 will simply show how to attach all the lines and operate it.

Hi. I had planned to finish part 2 by now, but a motorcycle accident has kept me away from my boat. I am recovering well and will be back at it soon. Yes, I believe the screws provided are stainless steel (and that the mast is aluminum), so yes, there is a risk of galvanic corrosion. According to the British Stainless Steel Association (www.bssa.org.uk/topics.php?article=89), "Although aluminium is anodic to stainless steel, large relative surface areas of aluminium to stainless steel can be acceptable, dependant on local conditions. Stainless steel fasteners in aluminium plates or sheets are normally considered safe ..." In my case, the boat is also not exposed to salt water, and again, according to the BSSA, "To complete the cell, a conductive liquid must bridge the contact metals. The more electrically conductive the liquid is, the greater the danger of corrosion. Seawater or salt laden moist air is more of a risk than contact with rain water." In conclusion, I think I'll be OK. What do you think? Or even better, what would you recommend? I'd like to avoid going up the mast any more than is needed :)

@@sailingfromswitzerland sorry to hear that, glad you're recovering. Thanks for the references. Sounds like it might be ok..? I'm personally just in brackish water (chesapeake bay) so not sure it would be a big problem here either then. Unfortunately it's a long time since I had chemistry so I don't know much more than that it is a thing:) I guess if your screws fail you'll know it's an issue.. I've read there is stuff you can apply to the screws before you install them to break (reduce?) the metallic contact.

obidamnkenobi Thanks! Also, it’s not a critical part of the boat, or one that is supposed to carry much load.

That will be a big problem in 10 years. Be sure to coat them in Duralac otherwise you will get corrosion.

I’m still waiting for my mountain-climbing friend to help me get up the mast, so I haven’t finished this project, nor filmed part 2. In the meantime I’ve just been folding the sail up manually, and I’m usually with some friends so they help. This lazy jack system is mainly to help me solo sail. Thanks for watching and sorry part 2 is still missing. Maybe I’ll finish it this summer. What brand did you buy? My instructions are pretty lacking too, but the little graphic I made in this video should help.

Max Thank you for the correction. I hope you enjoyed the rest of it.

@@sailingfromswitzerland just waiting for part 2 :P