The tape for the drill bit is very helpful. I will use that.
@Foryou-bv4lp11 ай бұрын
So, you kept the hole as on bottom plate? Am I understanding this correct?
@MattMadeIt12311 ай бұрын
Yes. The hole in the bottom piece will always be there. You never see it while using the lazy susan. Or you could go without a bottom round and just put rubber feet on the hardware.
@Foryou-bv4lp11 ай бұрын
@@MattMadeIt123 thank you for a quick response. Much appreciated! I was so confused when trying to make it work. 😂. Now it makes sense.
@unisonproductions123 Жыл бұрын
Thanks, how do you find the center to the lazy susan hardware?
@MattMadeIt12311 ай бұрын
I just do it by eye. Gets you very close.
@DaHuntersTrophy5 ай бұрын
My Susan didn't work, so I had to fire her lazy self.
@charizzkalum91378 ай бұрын
Pretty loud I assemble mine with a standard ball bearing much smoother and very quiet
@MattMadeIt1238 ай бұрын
Yeah. This is a Richelieu mechanism. Supposed to be good quality. It was way too loud and was swapped out for a much quieter one.
@charizzkalum91378 ай бұрын
@@MattMadeIt123 yea I tried most of them even the quality one's are pretty loud I routed a stem and a hollow for a high quality bearing and the difference is night and day I'll upload a quick video for you tomorrow morning and take a look I think you'll find it a game changer
@charizzkalum91378 ай бұрын
Super smooth and no noise just need a bit of accuracy on the router