Learn Plasticity: CAD Step By Step Tutorial - 2024 CAD vs CAD Quarter Finals Match 1

Рет қаралды 1,853

Күн бұрын

Plasticity tutorial for creating the models presented during Match 1 of the Elite 8 - CAD vs CAD 2024 Spring Open between @ExMachinaEngineering and Imants
@TooTallToby Livestream:
• CAD vs CAD Tournament ...
@PhosphOr75 Football:
• TTT 24-SPD-41 Hollow F...
#plasticity #CAD #tutorial #stepbystep
⏱ TIMESTAMPS ⏱
0:00 - Intro
0:20 - Model 1: Fan Bracket
0:35 - Analysis / Strategy
2:02 - Modeling
11:59 - Calculating the Mass
12:40 - Model 2: Hollow Football
13:14 - Disclaimer: Plasticity 1.4.18 vs Beta
13:50 - Modeling
21:30 - Tip: Use "duplicate" to create a new curve without overlaps
22:21 - Calculating the Mass
---
Previous video with step by step details on how to do Unit Conversions: • TTT 24-01-14 Slide Hin...
Music from creatormix.com/

Пікірлер: 16

@rogerramjet69 2 ай бұрын

awesome... was hoping you would do it... Id like to see you enter using plasticity :)

@davinchewk 2 ай бұрын

I am too slow at analyzing drawings to enter! If I can practice getting faster at coming up with a strategy, I might in the future.

@xxGytis15xx 2 ай бұрын

Nice vid, great tips, little fast for rookies but great non the less :)

@davinchewk 2 ай бұрын

Yeah I've been experimenting with pace to make things "less boring". But you're right, the video seems a bit rushed. I will slow things down for the next videos.

@rogerramjet69 2 ай бұрын

love how you tackled the foot ball. Golden ratio uses circles :)

@TooTallToby 2 ай бұрын

Awww yeah AWESOME JOB!!

@law6454 2 ай бұрын

Great Video!💚

@davinchewk 2 ай бұрын

Glad you liked it!

@colinhare4722 2 ай бұрын

I enjoy giving this a go before you do it to compare methods... The only thing significant that I would do differently is just copy the upper tangent line and using V change the local axis and move it 16.5mm parallel. Clearly where it intersects the 38mm offset line is where to centre the 33mm dia circle. Good video and excellent narrative as always.

@davinchewk 2 ай бұрын

Glad you liked the video! Thank you for the alternative approach. It's always interesting to me to see how other people think.

@davinchewk 2 ай бұрын

I just gave your approach a try, and it dawned on me that an even "faster" way (instead of duplicate, change pivot, then move) would be to simply use the offset command. But cheers - this is faster than the approach I took in the video.

@colinhare4722 2 ай бұрын

@@davinchewk Whilst I'd agree that offset should do it, It's my bad I know, but sometimes it just doesn't do it and I've not figured out quite why yet.