Lecture 4: Borehole logs, SPT tests, SPT Data Analysis, Drawing Cross-Sections, Common Mistakes

No video

Lecture 4: Borehole logs, SPT tests, SPT Data Analysis, Drawing Cross-Sections, Common Mistakes

Рет қаралды 18,491

Soil Mechanics and Engineering Geology

Күн бұрын

Пікірлер: 15

@Hami-vt1wz Ай бұрын

Does the correction factor also apply to standard unit of measurement or is the example shown for metric measurement only?

@robertflaviano8786 11 ай бұрын

Sir, how do we determine the soil bearing capacity for each depth?

@PCgamerChannel 10 ай бұрын

Use terzaghi bearing capacity of course

@elizabethlappay4962 Жыл бұрын

Hello, sir. How do I know or solve for the soil cohesion given the data? Thanks for the help

@meghnaaswal09 2 жыл бұрын

Greetings from India Mr. Ivan. Thanks a lot for all your easy to understand lectures and videos. I would request you if you could also make a easy lecture on Geotechnical Investigations for rock and soil for a Tunnel project or in general. How many numbers per test per Borehole and what should be the frequency of each test. Sort of elaborate document. It would be really helpful for all of us Engineers and Geologists.

@GeoEngineeringandScience 2 жыл бұрын

Thanks for the comment; usually all this is defined by a standard on geotechnical investigation which may vary in different countries. The standard will provide guidelines based on site conditions and the type of structure. I will try to make a video on this later.

@meghnaaswal09 2 жыл бұрын

@@GeoEngineeringandScience thank you Mr.Ivan. it would be extremely helpful if this document could be shared.

@Arunjuss99007 Жыл бұрын

Hi there, many thanks for the lecture. I was wondering if there was a method of interpolating between different sets of boreholes within a given area to create a cross section that does not nessecarily have the initial boreholes contained within it ? I know that the result of this would be fairly inaccurate as it would be based on assumptions of subterranian ground conditions but wanted to know if there was some sort of method to go about doing so as i havnt seen much outside of geospatial analysis software.

@javeriaafzal5305 5 ай бұрын

Can we do it for N30 normalization too?

@BlowdyeSalonMelbourne Жыл бұрын

Nice lecture..can I please get PDF file of this lecture

@vorpalsword8165 Жыл бұрын

Thank you so much for this lecture

@furathadi3959 2 жыл бұрын

thanks for your video . it is useful for me. i hope if you could learn me which Microsoft office use to make my report? and how i get legend for borehole logs?

@GeoEngineeringandScience 2 жыл бұрын

There is some free software to draw boreholes available on the Internet, you can find it there.