M3, How to make shutter tension increase. When the shutter curtain does not full open at 1/1000, you can adjust easily.
Пікірлер: 30
@alexpawelczyk24734 ай бұрын
Nobu, Thank you so much my friend. You Saved my camera from an expensive visit to the shop. I greatly appreciate your help.
@nobbysparrow4 ай бұрын
Hi, Thank you me too.
@charlescollins86497 жыл бұрын
Thanks, My first curtain was not opening all the way on the slower shutter speeds and on the fastest speed 1/1000th, the first curtain was not opening fast enough leading to a blank exposure because I think that the second curtain was closing before the first could open properly. This video was perfect and I think fixed my issue. Going to put a roll through it to test it out. Thanks!!!
@nobbysparrow7 жыл бұрын
I am glad to help you. Nobu
@aibarchin15 жыл бұрын
hi! i have the same trouble, did you fixed? thank you so much
@fredshovel42885 жыл бұрын
Thanks you Sensaï, problem solved on my Leica M2.
@jcaldrey10396 жыл бұрын
Hello, I have seen your video many times but I still am not so sure of which one of the screws I need to tight. The problem with my shutter is that (when set in one second) doesn't open entirely. It does open perfectly when set in Bulb. Thanks for sharing.
@nobbysparrow6 жыл бұрын
Hi, I think you may need to clean the slow governor.
@ben11723 жыл бұрын
how would you know if both curtains were adjusted to produce the right speed? As the curtains travel, is the gap between both of them supposed to remain the same?
@nobbysparrow3 жыл бұрын
As it is visible, the speed of the M Leica is easier to understand than Barnack Leica. However, it is a judgment by feeling. It's the same gap, only the opening times are different.
@clivejarmusch29062 жыл бұрын
Thank you for your video, Sensei. My M2 hav dark output on the left side of the photos, usually when using 1/1000 shutter speed. After researching, I suspect it's shutter capping. I should adjust the first curtain, right?
@nobbysparrow2 жыл бұрын
Yes, You have to increase the tension of first curtain. It is easy. Nobu
@clivejarmusch29062 жыл бұрын
@@nobbysparrow Thank you, Sensei.
@camr98345 жыл бұрын
先生ありがとうございました
@nobbysparrow5 жыл бұрын
ありがとう。
@Leon6D4 жыл бұрын
Hi nobby! used to buy split beam mirror on you for my IIIC thank you I installed it amazing!!! but now I have acquired a Leica M4 with shutter stuck wide open, just wanna ask what is the cause of it? sorry to ask but rhanks in advance if you could give me advice please!!!
@nobbysparrow4 жыл бұрын
I cant know correctly. There may be some reasons. Shutter mechanical problem. Shutter strap broken. Lower tension shutter. Little film chip or bodycovering chip stay inside.
@Leon6D4 жыл бұрын
くらもちのぶ ok rhank you so much!!!
@cw_uk7 жыл бұрын
good video NS!
@nobbysparrow7 жыл бұрын
Thank you !!
@DatTran4 жыл бұрын
My tip of 2nd shutter curtain is not fully hidden inside camera, I can see it in the film chamber. What tension screw should I turn to fully hide tip of 2nd curtain? Thank you
@nobbysparrow4 жыл бұрын
It's front screw.
@DatTran4 жыл бұрын
@@nobbysparrow Tight the 1st curtain screw even 2nd curtain's tip is shown? Thank you I'll try that.
Hi from Venezuela, I have a cuestion, my Leica M3 have the lever stuck (just go half way and no more) shutter button don't go all down. When I put the camera on R to rewind (should release tension and curtain) doesn't do nothing. What could I do? I hope u can help me. Thanks for u time.
@nobbysparrow5 жыл бұрын
I can't tell any advice, sorry. But try, Open the back door and turn the film advance gear with your fingers ?
@TostiRules5 жыл бұрын
@@nobbysparrow neither but thanks, really thankful that u answer me.