Hi Ron, yeah it's surprising eh. The stainless bar is quite weighty but that's the key to it really. I will make another with a row of pins for edging.but being soldered in,you can replace them easily or pattern them in the handle. It's even better with a few broad pins and some fine ones in the same handle

Are you referring to me Jeff 😂

@@tillysgunstocks 🤣🤣

Hi Mike, yes I'm sure you could cobble something together along those lines. The heavier you can make the handle section the better is what ive found. I've got a range of tools now with different diameters of nails and different quantities in each. The more nails ,the finer and shallower the stipple. The less nails the deeper it will stipple. Its good fun experimenting and really cuts down the time of the final job 😉

This one was made as a medium, based on the sizing of European target rifles.which would be more like a large in ar based grips😉

@@tillysgunstocks Yes, I was hoping you could give me the ratio of length to width, so I could try it myself and 3d print it. Thank you very much

It's cool eh,and it oils up nicer too than a dremel job. Without borders it's probably half hour to do a grip.😉