everything looked great until you were brazing without a trace of nitrogen.Also pressurize 1 line with nitro and cover other fitting with finger.Let it build a little pressure then let off a couple of times if there was any flux left inside it would come out. Just my 2cents.

Am a student so please normalize mentioning the parts.eg.suction,discharge.i love your video otherwise.

A very helpful tip to extend the life of the compressor is to add 50ml of sulphuric acid to the compressor before regassing. This helps keep the system clean.

That is not aluminum I think is steel pipe

Is this an invertor compressor..ahh I see it is... I've seen way too many inverter compressors go bad versus a standard compressor, I want to pull my inverter compressor out, install a standard compressor. any idea how to make it run from a signal from the inverter may be pulling in a relay

I also have an LG refrigerator and I know that I have to change the compressor but the challenge I am having is that I can't find a rating on the compressor to know which one exactly I am to buy.I will really appreciate you help in this area,how can I know the correct compressor that I have to buy .Furthermore,is it compulsory to buy a linear compressor if the one that came with the refrigerator gets bad and needs to be changed.

What kind of soder is it that you're using

Wonderful video but you never explained what type of torch you use ( is it a goss torch )and what gas it runs off of argon acetylene or propane?

Where can I buy that torch?

Hi Mel. Could you please share all the equipment needed for this job. I just got my EPA 1, certificate. I am just staring to set up, but not sure if I need to go high dollar on the equipment or I can just get something mid range for now.

Great content bro keep them coming

great video, what is the brazing rods you used here, thank you

Great video thank you. Now do I need to bleed the Freon and add new Freon?

Great video, here. What brazing rod are you using for brazing copper to metal. The one that is already coated with the flux.

Whar did you do with the electrical on this compressor? Did you purchase the Jig for the upgrade or install a relay to get a standard compressor to operate?

awesome Video

@Mels can you please show us if you must upgrade firmware / board and so on. I am curious if this is 1 to 1 swap without firmware adjustments?

It looks from the weld on compressor outer center, is not that good made compressor.

Hi not sure to ues your name on this site but if you can ,when your soldering are you useing the same products to connect?

Will a butain torch work for soldering the fittings?