I just did mine, a 2014 jeep Grand Cherokee 3.0 diesel. I noticed a difference with the idle feels better already. Mine's got 170000kms. Well worth it, I could see a difference inside, cleaned it up nice.

I use it after every service,on both inlet manifold and the turbo,does a good job well worth the money.

I use 2 cans at oil my changes. Thank you for the video. Viewer from the States.

I've heard CRD Fuel Enhancer additive is very good , and cleans your whole fuel system . It's from Cost Affective Maintenance 👍

I use this product few days ago my MPG 27 and after few days of driving i MPG 47 after cleaning get better and car run nice and quet than before cleaning

Thanks mate I've got an old 07 ranger that's been absolutely bullet proof, 223k and drinking deisel like it's fukin free, got some liqui moly and air flow sensor cleaner and new air filter, only getting 450k a tank in 5th gear at 90klms 1hour trip each way fukin driving me insane

I have also used this product. While the solvent is very effective on Diesel carbon, using as per the label does not effectively clean. I use the spray to soften the carbon then use cleaning pads or cloths to wipe it out. Use a rifle bore cleaning rod to get further inside with cloth wrapped around it or fully dismantle as i did this weekend - use the solvent to clean egr - intake - parts ect

I’m thinking about giving this a go so thanks for the video mate. Appreciate it!

To decarbonize your engine intake use oven cleaner, which is the best such as something like Mr Muscle is the best solution by far. I do use liquid Moly only for fuel treatment additives

When i take the intske hose off to throttle body then start the engine i cant rev it because the throttle body closes so csnt gdt that hose down there? Why is urs not closing is my throttle body faulty? Thanks

Hey mate, just about to do this to my Dmax, is it recommended to change the oil & filter afterwards?

This is where you need one of those bowel inspection cameras to do a before and after

An honest appraisal of the liquid moly cleaner. Looking at that you would have to use two or three can to clean it properly. I’ve just fitted a ryco catch can kit to my ranger at 50,000 km so hopefully it won’t get as bad.

Thanks sir👍

Do you have a video on cleaning injectors on the same model vehicle?

Did you getva mate to get it to 2000rpm whilest you sprayed?

I think u should just blank your EGR your engine will thank you for that

Mate, where did you buy this? Supercheap, Repco, Autobarn, Bursons - don't seem to carry this specific product any more?

Is it turbo safe? Can it be spayed down through the aircon?? (Past the filter into the turbo?

When u removed the intercooler piping, did the check engine light come ON? Thankyou :)

Close your EGR. Look my video friend. Thanks

G'day Mark, do either of you gents have any suggestion/input on the cost/benefits of a "catch can" or oil separator? They claim to prevent the buildup you're talking about this video. I've seen some on Diesel Care . com .au - any idea of their reliability?

That's what i dont want to do. Pull it apart. I'm not a mechanic but I've seen a few vids😳 an im thinking, bit the bullet an pull it apart,😅 then put it back together🤞🤣..an then run the spray to get the deeper carbon, trapped beyond the inner mannerfold.

Diesel use

where does the gunk goes after spraying it?

Did anybody else’s explode

I'm sure it cleans a fair bit of gunk off the intake but isn't anyone concerned about what sucking all that shit into the motor is actually doing to it? I won't be using that product.

Looks like liquid snake oil to me. :-) No different.

What a joke. Remove it and clean it properly.