Seriously, you can make these for 11 bucks plus tax! DOIT! Join the content team: www.patreon.com/MotoDudeAbides Social Media: Instagram - motodudeabides Facebook - TheMotoDudeAbides Business Inquiries: motodudeabides@gmail.com
Пікірлер: 29
@ricapone1814 жыл бұрын
i was about to spend way over a hundred bucks on axle sliders for front and back seen your video decided to go with the same color and steps walla perfect thanks motordude ur a money saver plus gave it a great look..
@sik1kraze4 күн бұрын
nice video! if you drill out the hole in the peg to 1/4" these make great peg sliders too.
@RuckinScott5 жыл бұрын
Make sure you’re using hard wheels. If you use the softer ones they have a tendency to grip and cause the bike to flip.
@TheGorillaBiker5 жыл бұрын
Aye, but a fine way to save some cash.
@RuckinScott5 жыл бұрын
Absolutely, and it doesn’t look bad either. Very useful tip/mod. Nice video
@MotoDUDEabides5 жыл бұрын
I’ve slid on these exact wheels. They are hard as far as skateboard wheels are concerned. They are for street boards so they are pretty firm. They are small enough too, that I don’t think they could generate enough leverage even if they did stick, to tumble the bike. Glad you dudes liked it!
@habitat23712 ай бұрын
Smart, definitely going to do this!!
@willglover82314 жыл бұрын
Thanks I'll try that
@dianaross29993 жыл бұрын
Happy to see your face!!
@anthonyscott1629 күн бұрын
Good job man. Hope you never had to test them. Thanks!
@TheGorillaBiker5 жыл бұрын
Nice video. But........I'm just hyper jealous of your garage :'(
@MotoDUDEabides5 жыл бұрын
The GorillaBiker it’s a work in progress... my wood shop takes up a bunch of space.
@Thatcressidaguy2 ай бұрын
Is it worth doing two on each?
@user-df1ss4qg7u Жыл бұрын
S@t. This is genius! Wish the skateboard wheels are cheaper then the cheapest moto sliders) I am on my way;)
@willglover82314 жыл бұрын
Hey does the drz have a axle seal? My 2017 the rod is not going through.
@ryanopolous56434 жыл бұрын
You may have the stock axle slider bolts stuck in there still, give it one big push
@MotoDUDEabides Жыл бұрын
See above comment
@dianaross29993 жыл бұрын
Do more videos
@talkingshed18652 жыл бұрын
Worked for me!
@MotoDUDEabides Жыл бұрын
Great!
@pushmotivation-__asher13355 жыл бұрын
What size Is. The thread rod?
@FastandHeavy4 жыл бұрын
3/8'
@MotoDUDEabides Жыл бұрын
3/8
@PercyJackson93 Жыл бұрын
Wouldn't the plastic wear off and just leave a bar sticking out to flip the bike?