Thanks for the support as always 🙏

@@earlmoorhead5555 thanks for filming videos for us after a long day's work 👊👍💯

Thanks

Thanks 🙏

Thank you! Cheers!

Lmao 😮

Yes still waiting on the front

Need a front wheel

Yes I feel the builders and testers had to have done it for sure

Because the more power and speed, the quicker the vehicle gets destroyed, especially in inexperienced hands.

@hashimrahman51 I’ve totaled a xo1 in ten min when they where released lmao 🤣

Don’t be scared

It doesn't need 3s it's plenty fast enough already ..

Yes Im wondering to 🤔

The firmware will not turn on that esc anything over 2S I showed this in a video throttle won’t work and error flashes

That 3s soft pack will squeeze in the lid won’t close tho

@earlmoorhead5555 I'll be turned in. I'll see.

Been doing some checks and now thinking where is 1cm when we want it

4s is the 120amp esc and it’s a little bigger

The Vendetta will only run on 3S , The ESC and the Motor can not handle 4S power , A 4S battery will most likely burn out ESC or over heat the Motor and cause it to fail , or both ESC and motor could fail , I would not recommend putting in a 4S battery , it can still hit 70 mph on 3S . If you want to go faster I would suggest you buy the Traxxas XO1 , 100+ MPH

@LionelGuy-oc8or have you watched my vendetta series? Let me say the motor handles way more then 4s lol but I have a playlist on it as arrma shared my vendetta review of 100mph one part changed before it was released to the public 👌👀

I have nitro rc cars 😮

Post up the content!!! I’ve seen the few vids of the Traxxas nitros, you should snag one of the new savage xl up! Have you built any nitro kits?

If you build a nitro kit and do a sweet series on it I have a cool engine I’ll send you to throw in it

@colorado_a3766 not in awhile as my time is limited right now as I’m moving houses

Once you get the time, please do it dude!!!!!

The 120amp 4s line of arrma esc are bigger then the 100amp esc 3s line ?

@@earlmoorhead5555 no they’re smaller , I know it makes no sense, take a look at one your 4s arrmas.

Yes I will I just have them packed up right now I’ll check my esc bin I should have a loose one

@@earlmoorhead5555 yes I looked, it’s same size as the 2s , they’re really pinched Pennie’s with escs , I guess if they offered 4s capable , no one would upgrade or over volt there motors , the hobby always for the first time buyer markets. Did you add the bec in the motorcycle or did come with ? I’m going go hobby shop today , if that have one I get it , I like the new bell rey but I’d want the livery one heat wave 👋

I feel like all these RTRs are underpowered escs , first thing I’ve been doing lately also , 3s to 4s. 4s to 6s , I wouldn’t be happy with 2s on anything anymore either , the over powering makes em RIP

⚡️👍👌

In the play list I show the modification needed to run 3-4S

@@earlmoorhead5555 excellent, thank you

Traxxas norm keeps parts around for there rc cars and I haven’t heard anything discontinued yet 🤷🏻‍♂️

@@earlmoorhead5555 Yeah this channel named speed fresh whom is also an rc’er like the two of us was telling me earlier in a comment section that the e Revo 2.0 has been discontinued. Shit if that’s the case and they still sale them brand new I may pick one up. I’m a big e Revo fan. Always been into truggys.

@gorillabeartech4577 speed fresh is a kid working at a traxxas store he should know

@@earlmoorhead5555 Well that’s what he told me. It’s unfortunate they discontinued it…. Hopefully if I can still grab one maybe I should.

Found the brand and studied the manual. But how to get permanent output voltage, without connect to an RX?

@antoninus1 the gyro motor and esc is all built into itself it’s only using the power ground off the receiver wire 🤷🏻‍♂️ no signal other then the activation for the controller I’ve explained it in the instructions videos on the external BEC I installed to run the gyro on 2S while upgrading the esc for the drive motor 💯

I think your thinking about the reciever wire and the gyro has it own to control on and off as that internal bec is set to 6V on the receiver to control the gyro on off switch the external bec is now the power source for the gyro and ties into the battery power you plug in and convert it to 2s no matter the battery you install now 🤷🏻‍♂️

Using a spectrum controller is already set up for the receiver and yes I’ve done several calibration videos there all the same no matter the rc car or bike

Buy the adapter kit and run a reef servo

Ok cool thanks Earl.@@earlmoorhead5555

Waiting on my super Moto tire to come in just received the rear last week all my parts are still on back order

With the super pro moto tire on the back how is it in grass?

It’s 1/4th scale motorcycle and the motor is 1/10 scale

@@earlmoorhead5555 Surprised and shocked man !. You’d think that it would have a 1/4th scale motor or I should say a 1/5th scale motor. Is this motorcycle the length of a Traxxas xmaxx or xrt ?..

Motors don't have scales ... It's a 540 sized ( 3860) 4 pole 3800 kv non sensored motor.

​​@@gorillabeartech4577the entire bike was scaled to the width the 540 ( 3860) motor took up .. motors don't have scales ..

@@roblapouple7552 You own a Losi Promoto X dirt bike or no ?…. What scale rc car can it be compared to length wise and height wise ?..

No it won’t let you

There set up for speed on the vendetta but I will check them

Going to a bigger amp draw will never increase run time 🧐

Idk 🤷🏻‍♂️maybe 10 mph more

See bike manual, stock esc can use 2S/3S. No matter which, 2s (7,4V) will come out for the gyro.

@antoninus1 go plug it in see what happens lmao 🤣

Appreciate your support very cool 😎