#cheezberger #exoalpinist
Low CG Transmission for RC Crawler, CheezBerger Transmission Vs Exo Alpinist Transmission
Exo Alpinist Transmission, 28% Overdrive & SORRCA Transfer Case Points Built In
Exo Alpinist Specs:
-Gr5 Titanium 48P Gears and Shafts
-Height (Top to Bottom): 39mm Length (Front to Back): 30mm Width (Side to Side): 53mm
-68g (2.4oz) Total Weight
-0% or 28% Overdrive Option with Dual Rear Outputs
-Portal or Straight axles
-16.07 Front Drive Ratio with an 11 Tooth Pinion
-Mirrorable Left or Right Side Motor Mount
-SORRCA Transfer Case Points Built In
-Fits Exo Trekker Skid
-Comes Assembled in Standard or Mirrored Configuration
-(2) M3x.5.8mm Hex Bolt and Tool Included
Cheezberger Transmission
All transmissions now come fully assembled.
Carbon Fiber Side Plates!
Heat Treated Chromoly Gears!
Uses 48P pinion.
Provides 17% overdrive.
Dimensions = 2.688 x 2.075 tall. Approx 59g
With this trans you get get 4:1 gearing not considering the spur/pinion.
MUST HAVE AN AXLE THAT CAN BE TURNED UPSIDE DOWN OR FLIP THE RING AND PINION SO IT CAN TURN OPPOSITE OF THE FRONT AXLE.
This trans uses an extra gear. This extra gear will give you an overdrive (or under drive depending on how you look at it) to the front axle. The amount of overdrive is approx the same as running under drive in the rear axle and over drive in the front axle. Because of this extra gear, the output shafts will turn opposite of each other which will really help with torque twist.
This trans is going to be great for people who cannot use the over drive front gear set in their axles due to Axials weak design in the ring and pinion. Now, people who need the ultimate in strength but want overdrive can run under drive gear sets with this transmission and have the same amount of over drive as the guys running the ring and pinions to get to the same spot. Additionally, its going to be pretty interesting as now you can run 2x the over drive to the front axle as before.