Ran into this scenario today hopefully it can help someone 😁 here’s a a link for spray adhesive amzn.to/3tNzJZi
Пікірлер: 8
@joshua82252 жыл бұрын
Iv had that happen before made the whole system leak a lot of water and glad I told my coworker like hey just bear with me and open that coil door and glad I did
@bobo11112222 Жыл бұрын
Nice. Very good Info Dude. 👍🏻👌🏻✌🏻🖖🏻❄️🔥 Subcool 10, chart says 10, tech adds refrigerant because suction is low. Uh-oh we got ourselves a parts changer. R410a I’m not sorry it’s going away. 410a suck ball. I hope next one is lower pressure like R22. But no, now mildly flammable. A lot of techs don’t flow nitro for braze, now you have to or 💥 KaBoom🔥
@jimzee122810 ай бұрын
Subcool shows condenser, subcool shows indoor side of the system. Always measure both , it's two separate readings.
@edwardgarza51042 жыл бұрын
I've seen issues with A coils with the point of the A towards the furnace causing high temp cut out during heat mode. The top of the A coil blocks alot of air as soon as it leaves the furnace. I know some of those say bi-flow but got to be careful on that.
@actsservicessa2 жыл бұрын
Makes sense
@thecatdaddy19742 жыл бұрын
Good Catch
@amanberhe22012 жыл бұрын
Thank you for sharing, you have probably saved me an exuberant amount of money from those money hungry guys!