Yeah I have a grid-platform that fits the interior dimensions and has feet in each corner to hold it up far enough from the impeller/bar. Then I have a stick that comes up to almost the top of the container so I can lift the platform and part that being cleaned up and out. I'm using these plastic containers you see in the video that have a rubberish seal around the lid but they are not super ideal because they have the small bump right where the impeller sits. I would prefer glass but that is much tougher to find and more expensive.

legacyofbob Right, really hate that small nub in the center bottom of the container. I just remove the IPA from it after us, keep it in a bottle, last time the resin in the dirty IPA hardened at the bottom, it was like cotton balls so I filtered it.

Was this build for a washing station? 👀👀

​@@ksharber🔴 What Is Islam? 🔴 Islam is not just another religion. 🔵 It is the same message preached by Moses, Jesus and Abraham. 🔴 Islam literally means ‘submission to God’ and it teaches us to have a direct relationship with God. 🔵 It reminds us that since God created us, no one should be worshipped except God alone. 🔴 It also teaches that God is nothing like a human being or like anything that we can imagine. 🌍 The concept of God is summarized in the Quran as: 📖 { “Say, He is God, the One. God, the Absolute. He does not give birth, nor was He born, and there is nothing like Him.”} (Quran 112:1-4) 📚 🔴 Becoming a Muslim is not turning your back to Jesus. 🔵 Rather it’s going back to the original teachings of Jesus and obeying him. More .....👇 🔴 THE RETURN OF JESUS

Here you go. www.thingiverse.com/thing:3692362

This is the stirrer and it comes with the pill shaped stirring bar which is coated with Teflon and should be food safe. The orange impeller is 3d printed and would not be food safe as FDM 3d printing introduces microscopic cavities in the plastic which can harbor bacteria, and resin-based 3d printing would be toxic. You could coat them in a food safe epoxy I suppose but I would probably just use the included Teflon bar. Here is the link, you'll need your own container. www.amazon.com/gp/product/B072K24X5P/

I've never used an autoclave. Since I believe autoclaves get up to about 130C I would think you would want to use PETG or ABS plastic since PLA heat deflection temperature is far too low. It would be even better to use a resin-printed version because they will have less surface imperfections and can withstand even higher temperatures depending on the type of resin.

6x3mm round magnets like this. www.amazon.com/gp/product/B07KZQGWNN/ Good luck!

I don't really sell them because the price is prohibitive. They are super cheap to make if you have a 3d printer. If you are hard up and really need one let me know and we can work something out. I think I still have the magnets around since I had to buy like 50 of them. If you are just looking for the stirring plate and teflon bar that used in the first part of the video you can find them here. www.amazon.com/gp/product/B072K24X5P/