Oh no problem!! Of course!

Thank you!

Are all setting different speed and power I ask cus I’m new I can’t find a video of the setting for a silicone case or watches so I’m wasting a lot of material lol because no one share a thing like if the world not big enough for everyone to get some change 💵

@@veemajeno7511 I know some people have tried settings for silicone at 600 speed 75 power and 675lpi. But I’ve had success using 1000 speed, 75 power, 340 LPI on silicone bibs. So I’d start with one of those! Maybe just do a small test on one of your items in several different spots if you have to :)

Engraving

The exhaust fan works well. Since we vent outside there is an order outside, but not much inside. We recommend you run an air purifier inside while running the machine to minimize any indoor smells.

Thanks so much! I appreciate you following :) I believe the total engrave for both pieces was around 20 minutes (12 for the rubber)

Here’s where I got mine… and it’s also on Amazon! crazylaserdad.com/products/rubber-stamp-sheets-5-pack

310/90/450lpi