Make Your Own Heavy-Duty Engine Stand (Part 3 of 3)

Рет қаралды 13,839

2 жыл бұрын

In this episode we finish up fabrication of a heavy duty engine stand made with steel 2x4's, a wheel hub from a Chevy Impala and a friction brake from a go kart.

Пікірлер: 21

@gerardfenn3988 2 ай бұрын

Watching you tinker with your shop lathe and machines brings me back to High School as they were the machines I used when in Brooklyn Technical High School. They were great times and I am always fascinated by what a man and a lathe can do. Great Video. I will give you a 98% for your ingenuity.

@barriejones15 Жыл бұрын

I followed all three videos, nice work, doing the best with what you've got/can source. We all make mistakes, great you can admit to yours, might make others think twice before making the same. Thanks for your efforts.

@RoadHead62 2 ай бұрын

I'm surprised you didn't source that splined shaft from a wrecking yard. The outer CV joint housing would make a great axle for the drive unit.

@YoshimoshiGarage 2 ай бұрын

I definitely considered it, and I still think it would have been the better route. But it was the middle of winter when I did this, and at the time I just couldn't overcome the idea of driving all the way to a pick and pull, wandering around in crap weather to find a donor, and pulling the part when I could just click a button. If I'm honest, age and the internet have made me soft.

@TheProchargedmopar 2 жыл бұрын

👍💪

@papergatorzfedducca7998 Жыл бұрын

How did you mount the engine? Do you have a video showing an engine mounted to it?

@YoshimoshiGarage Жыл бұрын

kzfaq.info/love/xFDpL91JoDVCzKR5tNVePQcommunity?lb=Ugkxp6n-q2MV9RtnEH41tyGFwVDOIhFLKADu

@besitstookeezbeshzhacuz9371 Жыл бұрын

Fuckin awesomeness bro

@damnimcooltom1 2 жыл бұрын

It's only for Chris.

@YoshimoshiGarage 2 жыл бұрын

Totally

@markhuyette8509 7 ай бұрын

you should have welded the handle to the hub

@classicstangbrn8964 2 жыл бұрын

Could have used an axle.

@YoshimoshiGarage 2 жыл бұрын

Would have been easier, for sure. But I didn't have one.

@classicstangbrn8964 2 жыл бұрын

@@YoshimoshiGarage , I would have hit the junkyard, but I don't have your skill of fabrication.

@YoshimoshiGarage 2 жыл бұрын

If I'm honest, I was too lazy. The nearest yard isn't that close, and I didn't feel like doing a pull. Of course a week after I finished this, a friend replaced his hubs and CV axles on a Cherokee, so it would have been a great donor.

@papergatorzfedducca7998 Жыл бұрын

So how does the engine mount to this?

@classicstangbrn8964 9 ай бұрын

What no hydraulic master cylinder, lol?