make your own sculptamold

Рет қаралды 3,878

2 жыл бұрын

This week I make my own Sculptamold using blown-in cellulose insulation and Plaster of Paris and fast set mortar
Lowes Canada
www.lowes.ca/product/blown-in...
www.lowes.ca/product/mortar/m...
Home Depot Canada
www.homedepot.ca/product/ther...
www.homedepot.ca/product/cust...
Making Sculptamold
Geek Gaming Video • How To Make Sculptmold...

Пікірлер: 10

@rosemaryr.long-morgan9704 4 ай бұрын

Thanks for sharing Dave. Good comparison (& more cost effective) diy scuptamold, appreciate it. Planning on a Dune for Wright Bros. Flyer (1/39 Scale Anniversary kit)

@1Klooch 2 жыл бұрын

One of the best DIY sculptamold demos I have seen. Valuable because of the comparisons. Thanks!

@pagodaracingmountpennreadi8915 2 жыл бұрын

Thanks Dave. This is the first of your videos I've watched. It was like watching "The Old Boys Kitchen"! LOL! I enjoyed it! I only need a small batch for my current project. Your video will definitely help me out. This old guy is looking forward to watching the rest of your videos. Thanks Again.

@Geordiecrafts Жыл бұрын

Fantastic tutorial! thanks for this!

@RDNTrains 2 жыл бұрын

thanks for sharing. looks a lot easier than Luke's method.

@Crookedriverandeasternrr 2 жыл бұрын

Thanks for sharing. I appreciate that you did a comparison of the three methods. Can I ask, do you know the working time of the plaster of Paris version. The one nice thing about the original is the working time for carving rock faces and such. Either way nice job. I liked and subbed. 👍 David

@mckerrowsiding 2 жыл бұрын

The working time is around 30 to 45 minutes. I work in small batches. After that it can still be shaped but it gets hard to work with.

@Crookedriverandeasternrr 2 жыл бұрын

@@mckerrowsiding ok thank you for your reply. I appreciate it. I think this is the way to go using the cellulose insulation

@mckerrowsiding 2 жыл бұрын

I make about a two cup mix. I mix it a little on wet to give time to work it

@Crookedriverandeasternrr 2 жыл бұрын

@@mckerrowsiding ok thanks for the info. I can’t wait to try this out