I made a benchtop jointer using with Makita 110mm power planer [1911B].
Пікірлер: 38
@puraessenciaaromas11 ай бұрын
Excelente 👍 Projeto simples pratico e objetivo!
@diy-maya11 ай бұрын
Thank you for your comment.
@Cahsolotree4 ай бұрын
Fantascic,new ideas for jointer. Thank you so much
@diy-maya4 ай бұрын
Many improvements are needed to work safely. Please update and work carefully.
@Cahsolotree4 ай бұрын
@@diy-maya thank you so much
@chielbloos4 ай бұрын
Nice simple design. Doable with basic tools also. However, I would include a safety - feature by means of a sliding block of wood above the spinning blades that slides away when a piece of wood is pushing against it when planed. Not that hard to construct... Nice work!
@diy-maya4 ай бұрын
Thank you for your comment. But, I think many improvements are needed to work safely, as other comments have said.
@eR-qz9pm Жыл бұрын
noice. super clean. 🔥
@diy-maya Жыл бұрын
Thank you for your comment.
@21thTek5 ай бұрын
Great !! ⭐⭐⭐⭐⭐
@diy-maya5 ай бұрын
Thank you for your comment. But, this method may be dangerous. Please be careful.
@mehmetturan4265Ай бұрын
muhteşem.!!! bu konudaki videoların en kullanışlısı ve kolayı,Türkiyeden çok teşekkürler.
@diy-mayaАй бұрын
Thank you for your comment. I think many improvements are needed to work safely. Please update and work carefully.
@mehmetturan4265Ай бұрын
@@diy-mayaThank you.👍
@icet70924 ай бұрын
Also known as the finger chopper.
@diy-maya4 ай бұрын
Many improvements are needed to work safely.
@mehmetturan4265Ай бұрын
bu tür elektrikli cihazlarda çok dikkatli çalışmak gerekiyor.
@barthoswerkstatt3 ай бұрын
👍😄👏👏
@diy-maya3 ай бұрын
👍 Thank you for your comment. But, I think many improvements are needed to work safely, as other comments have said.
@Magdah4806 ай бұрын
Коротковата площадка для строгания
@diy-maya6 ай бұрын
I think so too. Your point is right.
@user-st8bo4nb2s5 ай бұрын
指が何本あっても足りんな
@diy-maya5 ай бұрын
気を付けて作業します。 ご覧の皆様もお気を付けください。
@ConspiraGoose4 ай бұрын
Soo dangerous. My dad had his hand sliced up by doing something like this. Not worth the risk
@@diy-maya tener un protector sobre el filo y arremangarse para evitar que se pueda enredar la tela
@diy-maya5 ай бұрын
Thank you for your advices. Now, I have planned adding a protector and expanding the table. And, I will pay attention to my sleeves.Thank you for your specific pointings.