Рет қаралды 1,070
New molds are the absolute best. Makes hard jobs so much easier and get to offer that much more. Here i do a start to finish on drilling the mold, laying out the blocking, forming and then finishing this beautiful holster.
The retention on the mold needs to be adjusted slightly but i can also say that .093 thick material had a helping hand on how hard the retention was at first. The thicker the material the stiffer and harder it is to work with.
Hopefully you gained a tip or two on this journey and looking forward to the next video.
On to the next.
All Material from www.Holstersmit...
and/or www.Knifekits.com
Tell them I sent you!
Mold From
Palehorse
If you would like a holster, visit here👇👇👇
www.Faltacunlim...
If you'd like to email me, email here 👇👇👇
Faltacunlimited@yahoo.com
Follow FalTac Garage here👇👇👇
/ @faltacgarage
ALWAYS RESPECT THE HUSTLE
If you thumbs down this video, i hope you step on a lego hahah
"You'll never be criticized by someone who is doing more than you. You'll always be criticized by someone doing less. Remember That"
~Denzel Washington
"You're going to inspire some people, and piss off the rest. Might as well do it anyway"
~Unkown