Thanks!

It depends on a leather type. A Buttero's edge is burned slightly and I use only sandpaper like here or don't clean at all. But many types of leather burn badly and I have to use a sanding drum, as shown in this video :: kzfaq.info/get/bejne/oLt5n7mayqiVaGw.html

@@2rookawa Got you. Thanks so much for sharing.

Hi, thanks! I'm using local brand rubber cement. You can use any shoe repair glue, it should be flexible, so avoid cyanoacrylate (super glue). What liquid do you mean? I use clear water for molding, but it's not necessary. I also use Tokonole for edge burnishing, but it's not necessary too.

@@2rookawa Thank you for reply. I was asking about water it seems. xD I think that would be enough for me. Thanks again!

Thanks! The outer diameter is 45 mm.

@@2rookawa Thank you. And what is the inner diameter?

@@yaakovkhaikin8713 Based on available specifications and models, I assumed the inner diameter should be 26mm. But I cut 25mm diameter because the hole stretches after molding.

@@2rookawa That was an amazing job you did. It's just beautiful. Thanks a lot.

It's 3D-printed thing because I made the video before airtags were available. Now there is no problem to use a real airtag.

CO2 tube, 50W, 400x400 mm

CO2 laser cutter

Наэлектризовал, чтоб заготовка лучше фиксировалась

@@2rookawa 😁😆