Рет қаралды 92,041
Hello friends, this is the basic concept for making an arduino steering wheel, in this video I use a pulley made of wood to connect the motor dynamo with the axle, and for the next video I will try to replace the dynamo pulley with a gear made of wood. Later the best concept will be used for manufacturing arduiino 900 degree steering wheels.
The main ingredient :
Arduino Leonardo R3
Motor Driver BTS 7960
Sensor + Timing Disk Encoder for Canon iP 2770 Printer
Supporting Software:
Arduino drivers: bit.ly/2Kmv3TY
XLoader: bit.ly/2GJ62kY
Firmware: bit.ly/2Oz6Rmr
WheelConfig: bit.ly/2T5a37X
WheelCheck: bit.ly/31ij1BY
Thanks. ^ _ ^