A tip: if you ever want to use 2 spanners , use them with ONE hand Just position the 2 spanners, so you can squeeze them open (or close) with one hand. That can save a lot of injuries and evt. damage. Oh and never put a router bit ALL the way inside the Machine , slide it in till the end and then ever so slightly pull it back a mill or 2 and then lock it tight with the red stop button and one spanner.

Sick video matee! 🤙

Good job. Thank you I have the same setup but I haven’t used it yet. Nice to be shown how

Nice dude, I'll get some track after seeing this.

use both spanners in a position so you can squeeze them together with one hand to loosen the collet, also, you dont have to undo the rear two clips on the mbox

Nice demo

Hi! What size of V groove bit did you use? I want to do the same with my inside doors

Does anyone have an issue with the guide bushing it comes with not being centre to the bit or collet and know how to fix it? It goes off centre when i clip the lever down it looks like

Thanks for the video. Thinking of buying that makita track guide. May I ask if it has some sort of knobs to setting the clearance the guide and the track? Cheers

Fuck yeah just ordered my attachment 🤙🏽

Where did you get the guide from that slide to the track

I wish they make the adapter to fit the regular base as the dust collection is poor on their plunge base. I ended up making my own, but I shouldn't have to with the price they charge for the adapter, let alone the cost of the plunge base.

Jeez😳

Where do you get you’re trimmer cutter bits from bits from?

Why didn't you clamp the tracks to the door? I would have been afraid that they incidentely get out of place.

You have no idea how to remove or install a router bit , Why are you putting out videos about using a router ??

Ouch!