Adjusting the knives relative to the twine discs. Some specific notes on my baler setup.
Пікірлер: 9
@user-uh9xk7bm7h27 күн бұрын
I sure the dry knife is sharp. Also, the tension on the trying coming out of the boxes make a difference.
@oilsandedibles3427Ай бұрын
What size of screw caps are they do you know? I broke one off and need to replace it ( for the knot cutter blade ) thank you sir
@alkaliflathobbyfarm4961Ай бұрын
I believe they are in the range of 1/4-20 or 1/4-28, but that's almost as good as a wild guess, I would have to take one out to verify. Generally I take one out and run to town with it to make sure I get the right one.
@oilsandedibles3427Ай бұрын
@@alkaliflathobbyfarm4961 thank you so much !!!
@ryanleonard4082 Жыл бұрын
Any tips for changing out the billhook? We had the twine finger get loose and hit the needle, that bend the bill hook and I need to replace it...
@alkaliflathobbyfarm4961 Жыл бұрын
Sorry, I haven't had the pleasure of removing a bill hook yet. Good luck with your project!
@ryanleonard4082 Жыл бұрын
@@alkaliflathobbyfarm4961 Thanks! It was pretty easy actually Similar to a new Holland. Has a pin in the gear to punch out. Has to remove the knife and lift the knotter. But not a bad project at all.