MASTERCAM: CREATE TOOL PLANES ON A 4AXIS-HMC

Рет қаралды 12,353

7 жыл бұрын

UPLOADED ON REQUESTED
HOW TO CREATE TOOL PLANE ON A 4 AXIS HORIZONTAL MACHINING CENTER.
===========================
I'M SORRY FOR MY BAD ENGLISH
==========================

Пікірлер: 13

@cadcamworld3495 7 жыл бұрын

thank you Giang the tool for your toturial really helpful.

@ibrahimshamoon 7 жыл бұрын

thank you for video great

@3nginuur 7 жыл бұрын

Thank you. I will try it like you explained. If it is not too much trouble can you example program the part with the centered WCS for comparison?

@nabilelbadri7686 7 жыл бұрын

thanks a lot Giang , for the program generation on MC is it possible to keep just the top plane make the first face and then rotate the table 45 deg to make the side face and the same for the last face to make the program? thanks again rgds

@GIANGTHETOOL 7 жыл бұрын

yes, instead of creating 3 different tool planes and then using 3axis tool-paths on each plane, use can create 1 tool plane then use a Multiaxis-tool path, the part will automatically rotate.

@williamgrande8001 6 жыл бұрын

How do you have the tombstone appear on the plane?

@arifmalek8781 5 жыл бұрын

Muje ek baat jani he ke aapne ye Jo vertical Z ko y kese kiya aur y ko Z kese kiya please answer me

@tomnguyenarizona3425 5 жыл бұрын

How you changes vertical to horizontal

@nabilelbadri7686 7 жыл бұрын

thanks for your reply Giang the problem is how to match the X,Y,Z axis in mastercam and the machine setup X,Y,Z axis in G54? on the three faces

@GIANGTHETOOL 7 жыл бұрын

You can use a probe / indicator to measure distance from part to the rotary center, then put the part in same distance in mastercam.

@sekarkm9593 7 жыл бұрын

Hi Giang Thanks for your nice videos. How to configure a 4 Axis HMC machine Tree in Machine definition manager? I tried but not works. Machine Base-Table Group-HMC Z axis-HMC BAxis-Mill Machine Table- Fixture/Holder. Spindle Group HMC X Axis-HMC Y Axis-HMC Tool Spindle. While I save this Warning comes as This Machine does not have any valid axis combinations defined and cannot be used in a toolpath group Is it my tree correct could you please help me . I am learning myself. Thank you.

@socrates5573 5 жыл бұрын

Try to use mpmaster machine file and post, that's the easiest way to do it.