@bodbn 5 ай бұрын
wow great explanation of optirough. was looking for this.
@7077nghenhac Ай бұрын
Awesome
@KrólikUsznicki 4 күн бұрын
What if my opti rough tool path cuts sharp corners?
@jesusmendoza9759 2 жыл бұрын
great presentation thanks!
@zhenmingxiong1717 2 жыл бұрын
thanks so much
@PaulLantz-xp9no 3 ай бұрын
Why did you select Avoidance Geometry instead of Machining Geometry?
@jazkle 3 ай бұрын
I haven't used mastercam in about a year so I'm a little fuzzy on the reasoning. I just remember doing it that for years. You might be right to use Machining Geometry. Try it! Just make sure your simulation represents your actual work environment to avoid gouging and broken endmills. 😁
@joseantoniolopez3113 Жыл бұрын
thank