This tutorial looks at the use of the revolve and circular pattern tools on SolidWorks. Great tutorial for beginners.
Пікірлер: 10
@StuartHide4 жыл бұрын
Great video Dave much better quality in terms of the recording/screen resolution. Keep the videos coming - they are really helpful :)
@kingkidy_tz2 ай бұрын
10/10
@dennisb27632 жыл бұрын
Thank you, this was very insightful... I understand this isn't for the absolute beginner, it did take me a minute to figure out what you were doing with the lines as far as deselecting by hitting escape, etc. since it wasn't mentioned, but because I've been at it for a little bit, I was able to figure it out. A little note on the screen may make it more obvious to others if this is helpful feedback.
@quirose81973 жыл бұрын
Thank you
@ojoemmanuel98277 ай бұрын
Perfect
@hamody2012am2 жыл бұрын
Do you have any tips that enable me to understand the drawing model ? It’s easy to follow your sketch but hard to know how you sketch it ?
@guidetosolidworks37142 жыл бұрын
With this exercise being a revolve i always find it easiest to imagen that I am cutting the component in half and looking at just the cross-section. I rough out the shape that I can see in that view and then add dimension after. Hope that helps!!!
@nikkyhtown4964 жыл бұрын
neep help on a revolve part please
@guidetosolidworks37144 жыл бұрын
If u have a drawing send it to guidetosolidworks@gmail.com and I will have a look.