Mastering the TDR in 45 Minutes

Mastering the TDR in 45 Minutes - Eric Bogatin

Рет қаралды 33,334

Altium

4 жыл бұрын

Recorded at AltiumLive 2019 San Diego

Пікірлер: 17

@brokenicry 3 жыл бұрын

You know someone has mastered his craft when he can explain it to a beginner and the beginner understands it like a specialist... This is so great

@josephburton92 3 жыл бұрын

Thank you I appreciate this.

@leecyrille 3 жыл бұрын

Starts at 6:20

@alexiscozart3495 3 жыл бұрын

Thank you!

@javier-franciscomartinez4901 3 жыл бұрын

Thank you for this instructive presentation on TDR. It is very refreshing old myths relating transmission line reflections are explained with with clear and simple examples.

@diffynou 3 жыл бұрын

What is the difference between a TDR and a couple of function generator + scope ? Rise time is much faster on TDR devices ? No multiple interconnection reflections ? TDR can deliver much more power thus drive very long capacitive cables ?

@user-ww2lc1yo9c Жыл бұрын

This one is Part 1 of 6, where are the remaining parts?

@user-qy1oz2yj8x Жыл бұрын

A stupid question: how many reflections happened at each time position on the waveform? Only one reflection or accumulate of multi reflection? Such as there is bounce at the point of discontinue, is the bounce caused by one reflection?

@paulpaulzadeh6172 3 жыл бұрын

@35:14 , you get offset less then 50ohm , less resistive , is it ?! , but in other test you get higher offset , higher resistive , is it ?

@edouardmalot51 2 жыл бұрын

Can we get the small book online ?

@paulpaulzadeh6172 3 жыл бұрын

this means that on PCB , changing layer by via is not good if you want uniform 50 ohm impedance , is it ?!

@yeaveny3629 3 жыл бұрын

is it?

@Bornachiever17 2 жыл бұрын

No you can but maintain return path without screwed so use return vias on layer transition there is proper return path hence no impedance discontinuity

@TSRHelios 2 жыл бұрын

@@Bornachiever17 with a return via the signal via is like a very short microstrip without impedance control. I remember I have seen a US pattern regarding impedance controlled via.

@yuraamirov7893 Жыл бұрын

you are correct :) there is some way to improve it however . you can add some ground vias near by for the return path , by doing so , you will minimize the change of impedance

@allanknox8216 6 ай бұрын

Everbody responding is giving you good advice. Avoid layer changes if you can, and when you must, be sure you add some ground vias to compensate in the return path. You can then keep the discontinuity small and (hopefully) insignificant depending on operating frequency.